- Soyo Mainboard User's Guide & Technical Reference

SiS VGA Driver Installation SY-5STM

6-3.4 AutoShade R2.0 Setup

1. The following procedures assume that

Ø You have completed the “ unpack & copy” procedure.

Ø Your ADI 4.2 drivers are located in C:\ADI42.

2. Add the following settings to your own batch file for AutoShade

R2.0 (i.e. SHADE2.BAT) or to your AUTOEXEC.BAT file.

Ø For display driver settings:

SET DSPADI=\ADI42\RCPSIS.EXP

Ø For rendering driver settings:

SET RDPADI=\ADI42\RCPSIS.EXP

3. Delete the configuration file SHADE.CFG.

4. Type SHADE2 <Enter> to re-configure the AutoShade.

5. While prompting “ Select display device” choose “ P386

AutoDesk Device Interface display driver” .

6. While prompting “ Select rendering display driver.” Choose

“ P386 AutoDesk Device Interface rendering driver”.

7. Perform all the listed instructions and the system will start with

the desired display settings.

6-3.5 3D Studio Version 3.0 Setup

1. The following procedures assume that

Ø You have completed the “ unpack & copy” procedure.

Ø Your ADI 4.2 drivers are located in C:\ADI42.

2. Create your own 3D Studio V3.0 batch file (say 3DS3.BAT)

and add the following settings to it, or add the following settings

to your “AUTOEXEC.BAT” file:

Ø SET RCPADE=C:\ADI42\RCPSIS.EXP

Ø SET RDPADI=C:\ADI42\RCPSIS.EXP

3. Execute the new 3DS batch file or reboot the computer using

the new “ AUTOEXEC.BAT” to make the new settings effective.