User Manual

INSTRUCTIONS
No-Wire
™
Half Racks
1. Place the base on a flat work surface with the word
“BOTTOM”facing down.
2. Bend up one end plate. Snap the bottom tier end tabs into
the lower set of slots in the end plate. Be sure the bottom tier
imprinted numbers face up.
3. Position the top tier so that imprinted numbers face up and
align with the numbers on the bottom tier. Snap the top tier end
tabs into the upper set of slots in the end plate.
4. Bend up the opposing end plate and snap the bottom tier and
then top tier end tabs into their matching slots in the end plate.
5. Bend up one side tier support and snap the bottom tier and
then top tier side tabs into their matching slots in the side tier
supports.
6. Bend up the remaining side tier support and snap the bottom
tier and then top tier side tabs into their matching slots in the
side tier supports.
Submersible and works well in water baths
Autoclavable at 250º F (121ºC)
Empty racks can be stacked.
Note: Do not use with liquid nitrogen.
Bel-Art – SP Scienceware assumes no obligation or liability for any advice furnished by it,
or for results obtained with respect to these products.
All such advice is given and accepted at the buyer’s risk.
© 2015. All Rights Reserved.
Bel-Art® – SP Scienceware® is a division of SP Industries, Inc.
661 Route 23 South, Wayne, NJ 07470
TEL: [phone] • FAX: [phone] • www.belart.com 918748001 – 05/15
Tabs
Slots
(Actual tiers may
differ from diagram)
Side Tier Supports
Base
End Plates
BOTTOM TIER
TOP TIER