User's Manual

Module Configuration Manager
7-33
Transferring User-Defined Settings
Once you have configured the settings on your module you may transfer these
settings to the monitor for subsequent retrieval into other modules. (Refer to
Retrieving User-Defined Settings on page 7-33.)
When the transfer of settings into the monitor is complete, the transfer successful
message will be displayed.
Retrieving User-Defined Settings
To standardize the user-configurable options for similar modules, you can
configure a single module and transfer its settings to the monitor for subsequent
retrieval into other modules.
First, transfer the settings from the configured module into the monitor. Insert a
second module or remote module housing into the monitor and retrieve the
settings.
When the retrieval of data into the module is complete, a RETRIEVAL
SUCCESSFUL message will be displayed. If settings have not been previously
transferred into the monitor, a RETRIEVAL FAILED message will be displayed.
!
• User-defined default settings that have been transferred to the
monitor’s memory are available for retrieval into other modules
until (1) the monitor is powered OFF or (2) a patient is admitted
to or discharged from that monitor with a Purge Data/Yes.
!
• User-defined default settings that have been transferred to the
monitor’s memory are available for retrieval into other modules
until (1) a monitor is powered OFF or (2) a patient is admitted to
or discharged from that monitor with a Purge Data/Yes.
• Once retrieved, alarm ON/OFF status and alarm limits for all
parameters will be reset according to the newly retrieved
settings.
To transfer user-defined settings
from the module into the monitor:
Module Configurations with ECG
1 Touch ECG.
2 Touch SETUP.
3 Touch CONFIG.
4 Touch the hidden key 3 times.
5 Touch TRANSFER SETTINGS.
6 Select YES.
Module Configurations without
ECG
1 Touch TEMP.
2 Refer to steps 4 through 6
above.
To retrieve user-defined settings
from the monitor into another
module:
Module Configurations with ECG
1 Touch ECG.
2 Touch SETUP.
3 Touch CONFIG.
4 Touch the hidden key 3 times.
5 Touch RETRIEVE SETTINGS.
6 Select YES.
Module Configurations without
ECG
1 Touch TEMP.
2 Refer to steps 4 through 6
above.