User's Manual

System Introduction and Network Basics
1-5
Inserting Modules
Insert a module into the bedside monitor (Ultraview 1030/1050) or into the remote
module housing as shown below.
Figure 1-2: Ultraview Care Network module insertion
Patient Preparation
To prepare the patient for monitoring, attach the patient cable, and connect the
patient cable to the module. Touch a parameter key, then touch the menu keys as
needed to set up monitoring for a specific parameter.
!
• Check Setup is an optional feature on the ECG channel.
Contact your system administrator if your system does not have
this feature.
remote module housing
Ultraview 1030/1050
right side view
patient
module
slot
90499 Module Housing
patient
module
slot
Ultraview 1600 and
Ultraview 1700 Monitors