User's Manual

Ultraview Care Network
4-8
The PrintMaster printer functions the same as the bedside and system printer
modules in that it prints recordings of parameters in alarm conditions, requested
waveforms, and non-waveform data.
Clearing Paper Jams (PrintMaster)
If a paper jam occurs, a message will indicate the location of the jam. Once the
jam is cleared, the cover closed, and the printer warmed up, the printer will print all
the pages affected by the jam.
One of three paper jam messages may appear on the printer display:
Terminating a Print Job (PrintMaster)
To terminate an undesired multi-page print job that is currently printing, power the
printer OFF (until the front panel lights go out) then turn it back ON. This cancels
any print job in process.
Replacing the Toner Cartridge (PrintMaster)
When the TONER LOW message appears on the printer display:
1. Open the top cover.
2. Lift and pull the toner cartridge out at an angle.
3. Insert the new cartridge.
4. Close the top cover.
Table 1: PrintMaster Paper Jam Messages
PAPER INPUT JAM
1. Pull out the paper drawer.
2. Remove the sheet that did not feed.
3. Inspect remaining sheets to ensure they are not
wrinkled or stuck together.
4. Close the paper drawer.
5. Open and close the top cover to clear the paper jam
message.
PAPER FEED JAM
1. Open the top cover.
CAUTION! THE FUSING UNIT IS HOT.
2. Lift out the image drum cartridge.
3. Carefully remove the jammed paper.
4. Replace the image drum cartridge.
5. Close the top cover.
PAPER EXIT JAM
1. Open the top cover and the rear cover to release
the roller pressure.
CAUTION! THE FUSING UNIT IS HOT.
2. Pull the paper out from the rear or inside of the
printer.
3. Close the top and rear covers.