User's Manual

Printing
4-17
Loading Paper
Bedside Printer Module
The small black rectangular cue mark on the bedside printer paper must face out
and be at the bottom of the tray when loading paper into the tray.
Figure 4-4: Bedside printer module paper tray
Each recording starts at the Z-fold perforation and blank sheets are not placed
between successive print requests.
System Printer Module
The system printer module has a slide-out plastic tray that accepts packets of
Z-fold paper. The 2-channel printer uses 50mm wide by 27m long paper. The
4-channel printer uses 120mm wide by 45.7m long paper. Each sheet has a small
black rectangular cue mark located along the edge used to load the paper into the
tray.
Figure 4-5: System printer module paper trays (top view)
To load paper in a bedside
printer module (2-channel only):
1 Press eject button next to
PAPER OUT light.
2 Withdraw plastic paper tray.
3 Discard old cardboard retainer
inside tray.
4 Remove label from new paper
but keep cardboard retainer in
place around one end.
5 Start inserting paper into tray,
beginning with cardboard
retainer end.
6 With paper halfway into tray, lift
up spring-loaded roller.
7 Bring out top fold of paper from
under top end of cardboard
retainer.
8 Bring top fold over top of spring-
loaded roller.
9 Release spring-loaded roller
onto remainder of paper.
10 Insert stack fully.
11 Unfold paper and position over
top of black roller at end of tray.
12 Slide tray completely back into
printer module.
Note orientation of small cue mark
To load paper in a system printer
module (2- or 4-channel):
1 Press eject button next to
PAPER OUT light.
2 Withdraw plastic paper tray.
3 Discard old cardboard retainer
inside tray (2-channel only).
4 Remove label from new paper
but keep cardboard retainer in
place around one end
(2-channel only).
5 Discard 4-channel container.
6 Start inserting paper into tray,
beginning with cardboard
retainer end (2-channel only).
7 Make sure black squares are in
the top left corner of the pages
(4-channel).
8 Insert stack fully.
9 Unfold paper and position over
top of black roller at end of tray.
10 Slide tray completely back into
printer module.
4-channel
2-channel
paper roller
paper roller
cue mark
cue mark