User's Manual

Ultraview Care Network
4-18
Ultraview 1030/1050 Printers
The Ultraview 1030/1050 monitor’s printer uses 50mm wide by 30m long rolls of
thermal paper. The printer has an automatic self-feed mechanism for threading
the paper through the rollers.
Figure 4-6: Loading printer paper
PrintMaster
The PrintMaster printer has a slide-out paper drawer that accepts up to 500 pages
of letter or A4-sized copy paper. Slide the drawer out of the printer, place the
paper (according to orientation) into the cassette, and place the cassette back into
the printer.
Paper Out Conditions
All printers signal a paper out condition by periodically sounding a tone. The
PrintMaster will beep every 15-seconds when there is no paper in the cassette, or
the cassette is not loaded. In addition, the PrintMaster and the bedside printer
module flash the PAPER OUT light, while the 2-channel and 4-channel system
printer modules display a LOCAL PRINTER PAPER OUT message. On the
Ultraview 1030/1050 monitor’s printer, the PAPER OUT tone does not sound if the
local alarm tone key is set to OFF.
After reloading paper in the system printer module, the paper-feed mechanism
ejects a sheet to verify proper paper feeding. For the paper-feed mechanism to
work, you must leave the printer power ON while you are loading paper.
WARNING:
• While printers are off-line, or out of paper, they will ignore
any new alarm that would normally start a recording, and
no alarm or requested recordings will go into a queue.
CAUTION:
• Removing a bedside or system printer module from the
monitor to load paper causes an immediate loss of
pending print requests.
To load paper in the Ultraview
1030/1050 printer:
1 Press release button on door.
2 Open paper tray door all the
way.
3 Snap new roll into place.
4 Pull out 6 to 12 inches of paper.
5 Close door.