User's Manual

Ultraview Care Network
24-8
System Parameters
The system parameters sub-menu accesses the montage display, where
electrode lead placement is entered and EMG is enabled, the filters sub-menu,
used to set the high and low cutoff and line frequency filters, the display format
menu, used to choose the data format and the EEG label selecting sub-menu.
To enter electrode lead
placement: (processing must be
off)
1 Touch EEG.
2 Touch SETUP.
3 Touch INITIAL SETUP.
4 Touch SYSTEM PARAMS.
5 Touch MONTAGE.
6 Touch ERASE ARCHIVED
EEG DATA (if data is stored in
module).
7 Touch MONTAGE.
8 Select 2 or 4 channel.
9 Select desired channel.
10 Touch CLEAR CHANNEL.
11 Select desired electrode
placement sites.
12 Repeat steps 9 through 11 until
all channels are defined.
To set low cutoff, high cutoff and
line frequency filters:
1 Touch EEG.
2 Touch SETUP.
3 Touch INITIAL SETUP.
4 Touch SYSTEM PARAMS.
5 Touch FILTERS.
6 Select desired low cutoff, high
cutoff and line frequency
values).
To display EEG in dual format:
1 Touch EEG.
2 Touch DISPLAY FORMAT.
3 Select DUAL FORMAT ON.
To select an EEG label (if using
more than one EEG module in
one monitor):
1 Touch EEG.
2 Stop processing (if started).
3 Touch SETUP.
4 Touch INITIAL SETUP.
5 Touch SYSTEM PARAMS.
6 Touch SELECT LABEL.
7 Select desired label.