User's Manual

Remote Keypad
27-5
Selecting a Parameter
The parameter (waveform) keys display vertically near the right side of the screen,
with parameter number one at the top (except on a split screen central display).
Press the WAVEFORM key to activate the parameter (waveform) selection mode.
Operating Menu Keys
The menu keys display horizontally across the bottom of the screen with menu
key number one at the far left. Press the ZOOM key once to activate the zoom
feature, making each key easier to see. Press the ZOOM key again to turn OFF
the zoom feature.
Recording a Waveform
After you activate the RECORD key, you have 2-seconds to highlight a parameter
(waveform) key. To ensure enough time in making a selection, place the cursor on
the parameter (waveform) key and press the cursor for an additional 2-seconds,
before you press the RECORD key on the remote keypad.
!
• The remote keypad cursor remains on the screen for
approximately one minute following the last keypad activity or
until you touch the touchscreen itself.
!
• When printing several parameters at the same time or when
trying to print an event such as a single abnormal beat, it is
easier to use keys on the monitor rather than on the remote
keypad to direct the recording.
To select a parameter:
1 Point the remote keypad at the
monitor’s receiver.
2 Press WAVEFORM for
parameter number 1.
3a Press up or down arrow keys to
desired parameter.
-OR-
3b Press the number of the desired
parameter.
4 Press ENTER.
To operate menu keys:
1 Point the remote keypad at the
monitor’s receiver.
2 Select a parameter key.
3 Press MENU.
4a Press left or right arrow key to
desired position.
-OR-
4b Press the number of the desired
menu key.
To print data from a waveform
zone:
1 Point remote keypad at the
monitor’s receiver.
2a Press up or down arrow keys to
desired parameter.
-OR-
2b Press the number of the desired
parameter.
3 Press RECORD.
4 Repeat step 2a.
5 Press ENTER.