User's Manual

SpO2 (91343 only)
071-0774-00 Rev. A 3-3
Figure 3-2: Display Zone — Full Screen
Figure 3-3: Display Zone — Split Screen
 Current SpO
2
value (percent) and episodic time of reading. (Time is not
displayed when using continuous mode of operation.)
 The bell indicates that alarms are enabled (equal sign turns to a small bell
when SpO
2
alarms are enabled).
 SensorWatch bar:
Shaded area (waveform index, WFI) expands up proportionally to signal
strength; horizontal line is minimum signal level.
No shading (lowest waveform index) corresponds to no detected signal
strength or a faulty sensor.
Ensuring Accurate Monitoring
Each sensor requires site specific application procedures, and the following
general points will aid oximetry monitoring success.
• Choose a site that provides proper alignment of the LEDs and receiving
photodetector.
• Reduce light interference when monitoring under bright light by using a light
block over the sensor.
• Select a site that has unrestricted blood flow and can remain as immobile as
possible to reduce or eliminate movement artifact.
• Do not restrict blood flow when securing a sensor with tape.
• Do not select a site near potential electrical interference (e.g., electrical
cords).
• The SensorWatch bar should be above the minimum signal level.
E
C
G
XX YYY
PACED
A=XX
A/M 10
ROW 5
130
40
78
CHAN 2241
CHECK XX
ECG WAVEFORM ZONE
BED NAME PATIENT NAME
SpO2=98% 10:22

 
E
C
G
HR=XXX A=XX LEAD
ECG WAVEFORM ZONE
SpO2=98% 10:22
347-2 Jane Doe


CHAN 2241
