NIB (91343 only) Contents Sensing Up the ABP: Monitor: Setting or Adjusting Alarm Limits Displaying New or Previous Readings: NIB Alarm Message Summary NIB Troubleshooting Guide © Overview The 91343 digital telemetry mull-parameter transmitter sends NIB patient data, acquired by the 90217 ambulatory blood pressure (ABP) monitor, to the 90476 digital telemetry receiver.
SSO. Ultra view Digital Telemetry To set up NIB monitoring: 1:2: Configure 91343 DIF switch & 16 ON {refer to Figure 9-400 Page 47). 2 initialize 90217 with 90121 ABP report management system using the AGP Mole Management System:adapter ‘cable: 3: Apply appropriate uti: patient. 4. Attach cult to 80217 monitor. 5. Connect NIB adapter care between 90217 and 91343 Touch ECG: Touch CHANNEL FORMAT. Select NIB ON.
NIB (31343 only) Patient Factors Affecting Readings Excess patient movement; speech, or muscle contractions as a result of severe pain or shivering can interfere with automated NINE readings. Ensure that the. patient is pullet and not moving during NIB readings just 8s you would manual readings. The patient must avid applying external pressure to the cuff during readings. Institute measures to minimize ghivedng and alleviate pain.
SNE — Ultra view Digital Telemetry 4 Tablet: Curt Size by Limb Circumference Cuff Size Limb Circumference Pediatric 1310. 20cm Small adult 1710.26 cm Average adult 2410.32 om Large adult 321042cm Extra-large adult 3810 500m Position the cut so that the center of the inflatable bladder is directly over the Bronchial artery: The center of the bladder location is marked on the outside of. the cul. Once the proper positions determined, the cuff must be tightened to.
NIB (91343 only) Lead the hose up the arm with the cuff and place ®t across the back of the: patient. Drape the Hiss 50 it does not cause the patient discomfort and is not pinched shut by foo tight a radius. Figure 4-1 shows the most common positions for the cuff hose. alternative #1 alternative #2 Figure 4-1: Common Cult Hose Positions: Canned! the hose lo the monitor: To verify proper monitor operation, take one or more blood pressure readings.
Ultra view Digital Telemetry 11: Interconnect the adapter cable between the communications port on the: 0217 and the NIB port on the 91343 as shown in Figure 4-2. Spy adapter cable 4 i NIB cult A N Figure 4-2: Transmitter ECG, Sp Ox and ABP Monitor Connections Spc, sensor NIB adapter cable 90217 & 91343 mount in pouches io patient's belt: Figure 4-3 and Figure 4:4 on page 4-7: illustrate typical NIB displays.
3 To sel or adjust NIB alarms: Touch ECG. Torch ALARM LIMITS, Touch: NIB ALARM LIMITS: Select NIB ALM ON: Select SYS, DIA or MEAN: Select His els: Use arrow Keys io adjust. NUB IR NIB (91343 only) CHAN xix cl ee FCG WAVEFORM ZONE.
Ultra view Digital Telemetry To display previous readings in {tabular format {1030/1050}: Touch SPECIAL FUNCTIONS: Select LOCAL TRENDS or REMOTE TRENDS: ‘Select subset and bed number. Touch TABULAR TRENDS. Select TIME INTERVAL 0c ARBORS to adjust the time interval and period. {UCW and 1700): Touch: SPECIAL FUNCTIONS: Touch TABULAR TRENDS. Select LOCAL BED or REMOTE BEQ! Select bed number: Select TIME INTERVAL of ARROWS 10:adjust the time: interval and period.
NIB (91343 only) Tabular Trends Display Baa: ICU Patient: John Smith Late: 26 FEB 2001 Time. TSE 33 ESA BG SE AT ESE 3G HR{ECG) bi min ABN bin 505 8805 PR biotin {WF} 363 364 368 365 267 285 300 340 Nibs Time: 11:32 1137 mm Hg 100 102 Nibbled Time 11:32 137 mm kg 72 70 NIB Time 11:32 1137 nimble 20 79 NIB Alarm Message Summary The 90217 ABP monitor provides an extensive set of result codes that indicate the: status of the: monitor and the potential causes: of an inability to take a valid fading.
Ultra view Digital Telemetry NIB LOOSE OR NO CUFF Displayed when ihe cuff was able fo be inflated in'a manned indicating that was not attached lo the patient correctly. NINE PATIENT CANCELED. Displayed wham the patient kas pressed the STATUTORY button on the 80217, halting a reading in progress. NIBBLE BATTERY. Displayed when the primary (3xAAY battery voltage is tow, Replace with rash batteries.
NIB Troubleshooting Guide (continued) Clinical Situation Variable readings occur No NIB readings or questionable values in the presence of shock Cuff too tight QTL RL LAT Possible Cause Solution MB Date not retained. M Low or nic power. WM May be one of the following: timeout; no reading die to.
Contents Alarm Message Summary. 00 ECG Alarm Messages Sp Alarm Messages. NIB Alarm Messages Telemetry Alarm Messages. or a Alarm Message Summary Mast of the alarm message priorities in ultraviolet Digital Telemetry system are user-preset choices in the Module Configuration Manager menus (refer io the Module Configuration Manager chapter of the UCN Operations Manual): These. priorities are shown In this TONE column and allow selection bf ore out of four possible levels.
RAGA Ultra view Digital Telemetry ECG Alarm Messages The following messages apply when either the 91341, 91343, or 91347 i in use! GHEE XX. Displayed in the waveform zone, where XX is the name of the faulted electrode.
Alarms CHAN LEADS OFF: Displayed when a lead failure occurs on ECG channel | when automatic lead switching is disabled. CHAN 2 LEADS OFF Displayed when a lead failure occurs on ECG channel 2. The message is displayed in the waveform zone for both ECG channels 1 and 2: LO RATE ALARM Displayed during low rate alarms for the greater of 10 seconds or the duration of the lama NEW DOMINANT. Displayed for one minute when a switch ta a different dominant ECG homology Ours. NOISY.
AS Ultra view Digital Telemetry $0, AMBIENT LIGHT INCH. The ambient lift present is causing interference with ihe signal from the sensor: Attempt to reduce the amount of ambient light. SENSOR OFF PATIENT. The sensor is not properly applied to the patient. (This alarm is available only with non-disposable, fingerling type sensors.) SpO, INSUFFICIENT. SIGNAL. The signal amplitude from the sensor is not sufficient.
Alarms NIB EVENT CODE (x0) The eventide returned from the 90217 monitor is nol defined as ons of the other messages; Telemetry Alarm Messages The following are general telemetry messages and apply 16 the 8134191343; and 81347 transmitters: INTERMITTENT SIGNAL LOSS Displayed in the slalom zone whenever a minimum of the previous 100: Samples were missed. Al eve) 2/low priority alarm tone sounds after 10 seconds in This condition. LOW BATTERY: Displayed in the waveform zone when the transmitter voltage is low.