User's Manual

Connector # 1 – Power harness
• Connect green/black stripe to----------------- illumination
• Connect yellow to-------------------------------- ignition
• Connect black to----------------------------------directly to ground of battery
• Connect red to------------------------------------ directly to battery 12v positive
Connector # 2 – Sensor harness
• Connect green/white wire to------------------ left front pressure sensor
• Connect brown wire to------------------------- right front pressure sensor
• Connect purple wire to------------------------- left rear pressure sensor
• Connect red/white wire to--------------------- right rear pressure sensor
Connector # 3 – Solenoid harness NOTE: This harness will have a weatherpak connector on it that will
plug in to our existing RidePro solenoids. There will be no further connections necessary. If you have
another brand or type of solenoid, please refer to the connection instructions below for proper connection.
• Connect blue wire to -------------------------- left front UP solenoid
• Connect white/green wire to----------------- left front DOWN solenoid
• Connect brown/white wire to---------------- right front UP solenoid
• Connect yellow/white wire to----------------right front DOWN solenoid
• Connect green wire to------------------------ left rear UP solenoid
• Connect gray wire to--------------------------left rear DOWN solenoid
• Connect pink wire to---------------------------right rear UP solenoid
• Connect yellow/black wire to--------------- right rear DOWN solenoid
Installation notes:
1. The computer box should be mounted inside the vehicle to avoid moisture and to be accessible to make
programming changes. DO NOT MOUNT THE COMPUTER BOX IN THE ENGINE BAY OR
UNDERNEATH THE CAR.
2. Do not plug in the receiver module until all the wiring is complete.
3. The air pressure sending units must be grounded to function properly. This can be accomplished
through a metal mounting bracket or by attaching a ground wire to the main body of the sensor.
4. The control panel display unit can be flush mounted or surface mounted in any location inside the
vehicle…or it can be left unmounted. It is supplied with 6 ft. leads to the computer box. 12 ft. leads are
available from the factory if desired. DO NOT lengthen or shorten these leads…call the factory for a longer
harness.
5. The control panel is an LCD display. This display may be unsatisfactory if mounted at an extreme angle
to the driver. You may want to power up the system temporarily to insure you are able to see the display
properly in your selected mounting location.
How to program the air pressure presets:
To Program air pressure preset #1: This is the default setting that will be engaged every time the vehicle
is started. It can also be engaged via the [optional] keyfob transmitter by placing the slide switch in the “up”
position. It is recommended that this air pressure be adjusted to the highway ride height of the vehicle.
1. Place the DIP-switches located on the side of the computer box in the OFF [“up”] position
2.Turn ignition ON
3. Set desired air pressure of the vehicle with main control panel switches
4. Press the “program” button,
located on the side of the computer box 6 times, (If the program
button is held for 3 seconds on the 7
th
press of the button, level one will be set.) … the led beside the
program button will then flash (4 Times) to indicate programming was successful.