Guide

Page 57
NIGHT-LIGHT PENNANT
4
NIGHT-LIGHT PENNANT
Working With ProtoSnap
Like the E-Sewing ProtoSnap, the LilyMini ProtoSnap has all of its pieces wired
together, enabling you to test the circuit’s function before you sew. The LilyMini board
has a small push button to turn it on/off, located between sew tabs 3 and 4. With the
battery installed, press and release the button quickly to start up the LilyMini. The LED
on the LilyMini (between sew tabs 1 and 2) will turn green when it is on and the battery
has a charge, or it will turn red if the battery is getting low, then fade off. To power
down the LilyMini, press the button again.
Once powered up, the LEDs on the ProtoSnap should all be on, and the LilyMini’s
LED will glow white (Mode 1). Press the LilyPad Button to cycle through modes, which
use the light sensor to affect the behavior of the LEDs. Use your hand to cover the light
sensor and observe what happens to the two pairs of LEDs – when the light level is low,
the behavior of the LEDs changes. Press the button again to switch to the next mode.
LilyMini
ProtoSnap
S
Button
LEDs
Light
Sensor
1
4
3
2
+
_
Press to change mode
1
2
3
4
on
CR2032
LITHIUM BATTERY
3V
LilyMini
ProtoSnap
S
Button
LEDs
Light
Sensor
1
4
3
2
+
_
Press to change mode
1
2
3
4
on
CR2032
LITHIUM BATTERY
3V
LilyMini Power Button
LilyMini LED
mode color behavior
1 White All LEDs on
2 Magenta
LEDs fade in and out in a breathing pattern.
When the light sensor is covered, LEDs fade faster.
3 Cyan
LEDs off. When the light sensor is covered, LEDs will twinkle.
LilyMini
ProtoSnap
S
Button
LEDs
Light
Sensor
1
2
+
_
Press to change mode
4
3
on
1
2
3
4