Guide

Page 68
NIGHT-LIGHT PENNANT
4
Problems? See the Troubleshooting section
on page 70 to nd a solution.
LilyMini
ProtoSnap
S
Button
LEDs
Light
Sensor
1
4
3
2
+
_
Press to change mode
1
2
3
4
on
CR2032
LITHIUM BATTERY
3V
on
1
2
3
4
Installing Your Battery
and Testing
Insert the coin cell battery into the LilyMini’s battery holder
with the positive (+) side facing up. Press the power button on
the LilyMini; all four LEDs should light up (Mode 1). Press the
LilyPad button to switch between modes. Cover the light sensor in
each mode to check if the LEDs are changing when the light level
changes. If so, remove the battery and continue to the Finishing
Touches section.
After all the stitching is complete, turn the project over. Trim any
loose thread tails before testing.
CR2032
LITHIUM BATTERY
3V