Datasheet-2

a-Si TFT LCD Single Chip Driver
132RGBx162 Resolution and 262K color
ILI9163C
Page 10 of 200 Version:0.09
Pin Name I/O
Descriptions
TE O
Tearing effect output pin to synchronies MCU to frame writing, activated by S/W
command. When this pin is not activated, this pin is low.
If not used, please open this pin.
SDA I/O
When RCM1,RCM0=’1X’(RGB I/F), serial input/output signal in serial I/F mode.
The data is input on the rising edge of the SCL signal. The data is output on the
falling edge of the SCL signal.
When RCM1,RCM0=’0X’(MCU I/F), this pin is not used, and fix at VDDI or GND
level.
If not used, please fix this pin at VDDI or GND level.
PCLK I
Pixel clock signal in RGB I/F mode.
-If it’s not used, please fix this pin at GND level.
VS I
Vertical sync. Signal in RGB I/F mode.
-If it’s not used, please fix this pin at GND level.
HS I
Horizontal sync. Signal in RGB I/F mode.
-If it’s not used, please fix this pin at GND level.
DE I
Data enable signal in RGB I/F mode.
-If it’s not used, please fix this pin at GND level.
OSC O
Oscillator output or test purpose.
EXTC I
To use extended command set, please connect this pin to VDDI. During normal
operation, please open this pin. (It has an internal pull low resistor.)
EXTC=’1’, all the command can be used.
EXTC=’0’, only Command (00h~3Ah, DAh~DCh) can be used
IDM I
Normal mode and Idle mode control pin(Only for RGB interface(2))
IDM Idle mode H/W controller
0 Normal display (can be changed to Idle mode by S/W)
1 Idle mode
GM2,GM1,GM0 I
Panel Resolution selection pins
GM2 GM1 GM0 Resolution selection
0 0 0 132RGB x 162(S1~396 and G1~ G162 output)
0 0 1 128RGB x 128(S7~390 and G2~ G129 output)
0 1 0 120RGB x 160(S7~366 and G2~ G161 output)
0 1 1 128RGB x 160(S7~390 and G2~ G161 output)
1 0 0 130RGB x 130(S7~396 and G2~ G131 output)
1 0 1 132RGB x 132(S1~396 and G2~ G133 output)
RCM[1:0] I
RGB and MCU interface mode selection pin
RCM1 RCM0 Resolution selection
0 X MCU interface mode
1 0 RGB interface(1)
1 1 RGB interface(2)
SRGB I
RGB direction select H/W pin for Color filter default setting.
SRGB Color mapping selection
0
S1, S2, S3 filter order = ’R’, ‘G’, ‘B’
1
S1, S2, S3 filter order = ’B’, ‘G’, ‘R’