Wireless Module SparkLAN WNFB-266AXI(BT) & AP12275_M2 HW User manual Version 0.1 Revision History Date 2020/11/26 2021/01/04 Revision Content Initial released Updated picture of device. Revised By Version Ares 0.0 Ares 0.
Wireless Module Contents Revision History............................................................................................................... 0 1. WNFB-266AXI(BT) & AP12275_M2 Evaluation Board Introduction ........................ 1 1-1. Interface Highlights ........................................................................................ 1 List of Figures Figure1. Top view of WNFB-266AXI(BT) & AP12275_M2 EVB ....................................................
Wireless Module 1. WNFB-266AXI(BT) & AP12275_M2 Evaluation Board Introduction The WNFB-266AXI(BT) & AP12275_M2 evaluation board (EVB) is shown in Figure 1. This specifically provides customers as a test application for WNFB-266AXI(BT) & AP12275_M2 products. It provides communication interface conversion, functional I/O voltage level switching, and external power supply test points. There are controller pins on evaluation board which describes as below. Figure1.
Wireless Module Federal Communication Commission Interference Statement: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Wireless Module maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with this device. Unique antenna connector (RP-SMA) must be used on the Part 15 authorized transmitters used in the host product. Antenna Type Antenna Model Maximum Gain (dBi) 2.4 GHz 5GHz Dipole AD-103AG 2.02 dBi 2.03 dBi Dipole AD-302N 3.14 dBi 2.73 dBi Dipole AD-303N 3.14 dBi 3.
Wireless Module Industry Canada statement: This device complies with Industry Canada license-exempt RSSs. Operation is subject to the following two conditions: 1) This device may not cause interference, and 2) This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
Wireless Module Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Déclaration d’exposition aux radiations: Cet équipement est conforme aux limites d’exposition aux rayonnements IC établies pour un environnement non contrôlé.
Wireless Module Le produit final doit être étiqueté dans un endroit visible avec l'inscription suivante: "Contient des IC: 6158A-NFB266AXIBT ". Manual Information To the End User: The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the user’s manual of the end product which integrates this module. The end user manual shall include all required regulatory information/warning as show in this manual.
Wireless Module distance d'au moins 20 cm de personnes. le manuel de l'utilisateur final doit inclure la partie 15 / (fac rss gen déclarations de conformité relatives à l'émetteur que de montrer dans ce manuel. le fabricant est responsable de la conformité de l'hôte, le système d'accueil avec le module installé avec toutes les autres exigences applicables du système comme la partie 15 b, ices - 003.
