User Manual

ManualsBrandsSparkLAN Communications ManualsElectronicsWi-Fi 6E BT 5.2 M.2 2230 Module

Wireless Module

WNFQ-269AX(BT)

Manual

Standards

IEEE 802.11ax/ac/a/b/g/n (2T2R)

Bluetooth V5.2, V5.1, V5.0, V4.2, V4.1, V4.0 LE, V3.0, V2.1+EDR

Chipset

Qualcomm Atheros WCN6856

Data Rate

802.11b: 11Mbps

802.11a/g: 54Mbps

802.11n: MCS0~15

802.11ac: MCS0~9

802.11ax: HE0~11

Bluetooth: 1 Mbps, 2Mbps and Up to 3Mbps

Operating Frequency

IEEE 802.11ax/ac/a/b/g/n

ISM Band, 2.412GHz~2.484GHz, 5.150GHz~5.850GHz ,5.925~7.125GHz

*Subject to local regulations

Interface

WLAN: PCIe

Bluetooth: USB

Form Factor

M.2 2230 E Key

Antenna

2 x IPEX MHF4 connectors

Main: WiFi

Aux: WiFi/BT

Modulation

Wi-Fi:

802.11b: DSSS (DBPSK, DQPSK, CCK)

802.11g: OFDM (BPSK, QPSK, 16-QAM, 64-QAM)

802.11n: OFDM (BPSK, QPSK, 16-QAM, 64-QAM)

802.11a: OFDM (BPSK, QPSK, 16-QAM, 64-QAM)

802.11ac: OFDM (BPSK, QPSK, 16-QAM, 64-QAM, 256-QAM)

802.11ax: OFDMA (BPSK, QPSK, 16-QAM, 64-QAM, 256-QAM, 1024-QAM,

2048-QAM,4096-QAM)

BT:

Summary of content (11 pages)

PAGE 1
Wireless Module WNFQ-269AX(BT) Manual Standards Chipset IEEE 802.11ax/ac/a/b/g/n (2T2R) Bluetooth V5.2, V5.1, V5.0, V4.2, V4.1, V4.0 LE, V3.0, V2.1+EDR Qualcomm Atheros WCN6856 802.11b: 11Mbps 802.11a/g: 54Mbps Data Rate 802.11n: MCS0~15 802.11ac: MCS0~9 802.11ax: HE0~11 Bluetooth: 1 Mbps, 2Mbps and Up to 3Mbps IEEE 802.11ax/ac/a/b/g/n Operating Frequency ISM Band, 2.412GHz~2.484GHz, 5.150GHz~5.850GHz ,5.925~7.125GHz *Subject to local regulations Interface Form Factor WLAN: PCIe Bluetooth: USB M.
PAGE 2
Wireless Module Header: GFSK Payload 2M: π/4-DQPSK Payload 3M: 8-DPSK Power Consumption TX mode: 783 mA (Average ) RX mode: 362 mA (Average) Operating Voltage DC 3.3V Operating Temperature Range -10°~+70°C (Operating) Storage Temperature Range -40°C~+85°C Humidity 5%~90% (Operating) (Non-Condensing) 5%~90% (Storing) Dimension L x W x H (in mm) 30mm(± 0.15mm) x 22mm(± 0.15mm) x 2.15mm(± 0.3mm) Weight (g) 2.
PAGE 3
Wireless Module Installation l l l Connect the Module to the PCIe slot of the computer. Install Wi-Fi driver driver. After the Wi-Fi Driver is installed , click the Network icon on the Windows, then search the network , and connect the Wireless Network you want.
PAGE 4
Wireless Module Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
PAGE 5
Wireless Module 2.3 Summarize the specific operational use conditions The module is tested for standalone mobile RF exposure use condition. Any other usage conditions such as co-location with other transmitter(s) or being used in a portable condition will need a separate reassessment through a class II permissive change application or new certification. 2.4 Limited module procedures Not applicable. 2.5 Trace antenna designs Not applicable. 2.
PAGE 6
Wireless Module This transmitter is tested in a standalone mobile RF exposure condition and any co-located or simultaneous transmission with other transmitter(s) or portable use will require a separate class II permissive change re-evaluation or new certification. 2.10 Additional testing, Part 15 Subpart B disclaimer This transmitter module is tested as a subsystem and its certification does not cover the FCC Part 15 Subpart B (unintentional radiator) rule requirement applicable to the final host.
PAGE 7
Wireless Module Industry Canada statement: This device complies with ISED’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Le présent appareil est conforme aux CNR d’ ISED applicables aux appareils radio exempts de licence.
PAGE 8
Wireless Module In the event that these conditions can not be met (for example certain laptop configurations or co-location with another transmitter), then the Canada authorization is no longer considered valid and the IC ID can not be used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate Canada authorization.
PAGE 9
Wireless Module (i) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems; (ii) for devices with detachable antenna(s), the maximum antenna gain permitted for devices in the bands 5250-5350 MHz and 5470-5725 MHz shall be such that the equipment still complies with the e.i.r.p.
PAGE 10
Wireless Module DETACHABLE ANTENNA USAGE This radio transmitter [IC:6158A-WNFQ269AXBT] has been approved by Innovation, Science and Economic Development Canada to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with this device.
PAGE 11
Wireless Module 取得審驗證明之低功率射頻器材，非經核准，公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計之特性及功能。低功率射頻器材之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。前述合法通信，指依電信管理法規定作業之無線電通信。低功率射頻器材須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。 1. 應避免影響附近雷達系統之操作。 2.