WUBR-507N(LFG) 802.11a/b/g/n USB Module Quick Installiaton Guide Version 1.
Contents 1. Package Contents........................................................................................................... 3 2. WLAN Adapter Quick installation Guide.......................................................................... 4 3. Network Card Installation................................................................................................ 4 4. Connect to Wireless Access Point ..................................................................................
Copyright statement No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, whether electronic, mechanical, photocopying, recording, or otherwise without the prior writing of the publisher.
1.
2. WLAN Adapter Quick installation Guide Please follow the following instructions to use Ralink config utility to connect to wireless access point. 3. Network Card Installation 1. Install the WUBR-507N(LFG) USB Module into your computer. Never use force to insert the card, if you feel it’s stuck, flip the card over and try again.
2. If he following message appear on your computer, click ‘Cancel’. 3. Insert the Driver CD then wait for the Autorun prompt.
4. If Autorun does not work, please browse the CD content and double click the “Autorun.exe”. 5. Click the “Driver” for beginning the installation. 6. Click “Next” and then follow the instructions on the screen to continue the installation.
7. When you see this message, please click “Finish” to complete the driver installation process.
8
4. Connect to Wireless Access Point 1. After installation is complete, a small Ralink icon appears in the notifications area of the taskbar. You can double click it to maximize the RaUI dialog box. 2. When starting RaUI, the system will connect to the AP with best signal strength without setting a profile or matching a profile setting. When starting RaUI, it will issue a scan command to a wireless NIC. After two seconds, the AP list will be updated with the results of a BSS list scan.
Configure Connection with WPA2-PSK). a. Select the AP and click “Connect” icon . b. Authentication/Encryption function appears.
c. Select WPA2-PSK as the Authentication Type. Select TKIP or AES encryption. Enter the WPA Pre-Shared Key. d. Click "OK". Be careful, if the WPA Pre-Shared Key entered is not correct, you won’t be able to exchange any data frames, even though the AP can be connected.
4. At last, if you want to know more using method of RaUI, you could refer to the help file by click the question mark at the top right corner of RaUI to open it.
WUBR-507N (M) ■ Chipsets: Ralink RT3572 ■ Compliant with 802.11a/b/g/n Dual-Band standard ■ Interface: 6-Pin or USB 2.0 Type A (optional) ■ Antenna: 2 x U.
WUBR-507N (M) ■ WUBR-506N 802.11a/b/g/n dual band USB Module ■ WUBR-125GN 802.11b/g/n USB Module Ordering Info ■ WUBR-507N(M) 802.11a/b/g/n USB Module WUBR-507N(M) U.FL+6-Pin WUBR-507N(MU) U.FL+USB Type A WUBR-507N(P) Printed Antenna +USB Type A WUBR-507N(P6) Printed Antenna +6-Pin -------------------------------------------------------------------------------------------- Related Product Specifications Standard 802.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a re sidential i nstallation. This e quipment gene rates, uses and can radi ate radi o frequ ency energy and, i f not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
This radio transmitter FCC ID: RYK-WUBR507N has been approved by Federal Communication Commission to operate with the antenna types listed below with the maximum permissible gain indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. Ant. Antenna Type Model 1 Dipole C642-510049-A(SSR-12024)(X4) 2 Printed N/A Peak Gain (dBi) 2.4G 2 5G 2 2.4G 1.78 5G 3.
