User's Manual

EXT 1824G User’s Manual 1. Safety Information
EXT 1824G-UM-COM-EN-03 10
WARNING
Installation and environment of use
- Do not install the equipment in any of the locations listed below. Doing so may result in
malfuction, equipment faillng, fire or injury.
ㆍ Close to facilities where water is used.
ㆍ Where it may be exposed to direct sunlight.
ㆍ Close to the air outlet of an air-conditioner or ventilation equipment.
ㆍ Close to a heat source such as a heater.
ㆍ Where the power supply is unstable.
ㆍ In a saline or sulfurous environment.
ㆍ Where temperature or humidity is high.
ㆍ Where there is freezing or condensation.
ㆍ In areas prone to vibration.
ㆍ On an inclined surface or in an unstable area.
- Because the equipment cable is long, take care that cables do not become tangled during
use. Also, be careful not to get your feet caught in the cable.
Otherwise, it may cause a malfunction of the equipment or injury of the user due to tripping over
the cable.
Power supply
- Always connect the three-core power cord plug to a grounded AC power outlet.
- To avoid the risk of electric shock, this equipment must only be connected to a power
supply that maintains protective earth”.
- To make it easy to disconnect the plug at any time, avoid putting any obstacles near the
outlet. Otherwise, it may not be possible to disconnect the plug in an emergency.
- Be sure to ground the equipment to an indoor grounded connector. Also, be sure to
connect all the earth connections for the system to a common ground.
- Do not use any power source other than the one provided with this equipment.
Otherwise, fire or electric shock may be caused due to leakage.
Handling
- Do not spill liquid or chemicals onto the equipment.
Doing so may result in fire or electric shock.
In such a situation, protect the equipment with a disposable covering as necessary.
- Turn OFF the power to each piece of equipment for safety when not being used.