User's Manual

EXT 1824G User’s Manual 4. Detector Component
EXT 1824G-UM-COM-EN-03 44
5.4. Detector Initialization
Table5.5. Detector Initialization
Time Action Lamp Status
0 sec Press AP button. All lamps keep their own status.
2 sec
Keep pressing AP button.
AP lamp(blue) is blinking.
10 sec AP(blue) and Busy(orange) lamp is blinking.
15 sec
AP lamp is shown its own status.
Ready(green) lamp is blinking.
After
15 sec
Release AP button when Ready(green) lamp is
blinking.
And then press AP button 3 times again within 5 sec.
Busy(orange) lamp is turned on the light during
factory reset.
The letter "Factory Reset" is displayed on OLED.
It takes about 10 seconds.
• Detector will be connected again after the initialization
• Setting the parameters of detector such as SSID, IP, etc.
Refer to "7.2.1. Detector Configuration".