Users Manual

PRODUCT APPROVAL SHEET –WPEQ-256ACNRBI [W]
9
15.407(a)(1)(i).
The OEM integrator is still responsible for
1. ensuring that the end-user has no manual instructions to remove or install module
2. the FCC compliance requirement of the end product, which integrates this module.
3. Appropriate measurements (e.g. 15 B compliance) and if applicable additional equipment authorizations
(e.g. Verification, Doc) of the host device to be addressed by the integrator/manufacturer.
4. The separate approval is required for all other operating configurations, including portable configurations
with respect to Part 2.1093 and different antenna configurations
The user manual of the end product should include
1. Any changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate this equipment.
2. the restriction of operating this device in indoor could void the user’s authority to operate the equipment.
3. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna
or transmitter.
4. This equipment should be installed and operated with minimum distance 20cm between the radiator &
your body.
5. The FCC part 15.19 statement: This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Label of the end product:
The final end product must be labeled in a visible area with the following " Contains TX FCC ID:
RYK-WPEQ256ACN".
The end product shall bear the following 15.19 statement: This device complies with part 15 of the FCC
Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.