Operation Manual

Page 16 of 57
RD-OI-20 A/3
2.5 Li-Polymer Battery
The battery supplies power to the detector while in wireless connection mode. When operating, only
use the dedicated battery and charge it completely before use. To charge the battery, perform the steps
below.
1 Connect one end of 24V DC power cable to the “PORT” of the power box, and the other end to
the DC input port of the charging dock.
2 Connect the AC power cable with power box and power supply.
3 Insert the battery into the charging dock.
4 Open the power switch of the power box. And make sure the power LED of the power box and
charging dock are green indicating the presence of direct current (DC) power.
5 Charging should begin automatically. Verify that the charge LED shows a blue light. Once the
battery is completely charged, the charge LED should show a green light.
6 Once completely charged, gently pull the charged battery to remove it from the charging dock.