Operation Manual

Page 20 of 57
RD-OI-20 A/3
Gigabit LAN Cable
X-ray Tube
Shielded X-ray Room
DROC Workstation
CareView 750C
Power Box
Interface Cable
AC 100V
-240V
X-ray Generator
Sync cable
Control Panel
Figure 9 External sync mode
3.2.2 Software Sync Mode
The detector communicates with an X-ray generator via the DROC workstation via a wired or wireless
network connection. Compared with the external sync mode, the software sync mode will cause a
delayed response.
The sequence chart of software sync mode for a complete cycle of image acquisition is shown in figure
below.
Hand Switch 2
nd
Gear
X-ray ON
pressed
Exposure Time
released
SOFT_SYNC_EXP_REQ
SOFT_SYNC_EXP_EN
Figure 10 Sequence chart
A typical configuration for software sync mode of a DR system integrated with CareView 750Cw is
shown in the figure on the following page.