Operation Manual

Page 23 of 57
RD-OI-20 A/3
Gigabit LAN Cable
X-ray Tube
Shielded X-ray Room
DROC Workstation
CareView 750C
Power Box
Interface Cable
AC 100V
-240V
X-ray Generator
Control Panel
Figure 14 Manual sync mode
3.2.4 F
2
AED
There is no sync exposure signal interaction between the detector and an X-ray generator. Users can
begin exposure at any time once the device is ready.
The DR system in auto sync mode is configured exactly like the DR system in manual sync mode.
Note: If no goal image appears, first verify the exposure dose to see whether it is too low. Then, check
the tube’s field of view to verify that it completely covers the plate.
3.3 Network Connection and Power Supply
CareView 750Cw and the DR station communicate either wirelessly via a wifi protocol or via a
physical link by using a backup cable.
3.3.1 Wireless Connection Powered by Battery
The figure on the following page illustrates the recommended network connection setup. It can be
applied in mobile DR, RAD DR, or refined DR systems.