Operation Manual

Page 24 of 57
RD-OI-20 A/3
Wireless AP
DROC Workstation
Shielded X-ray Room
Gigabit LAN cable
IEEE 802.11n
CareView 750Cw
Figure 15 Wireless connection powered by battery
Note: If the X-ray generator is installed in a shielded X-ray room, it is recommended that the wireless
AP is also placed in it. The shielded X-ray room may be shielding the wireless signal. A DROC station
that connects with the wireless AP through a CAT-6 network cable will ensure a stable wireless
network connection.
3.3.2 Wireless Connection Powered by Power Box
The second method is the same as the first connection mode except for the power mode. In this mode,
the detector is powered by power box. If the battery is placed in the detector, it will be charged.
Wireless AP
DROC Workstation
Shielded X-ray Room
Gigabit LAN cable
IEEE 802.11n
CareView 750Cw
AC 100-240V
Power Box
Interface Cable
Figure 16 Wireless connection using wireless AP (Powered by power box)
3.3.3 Wired Connection
When the detector is powered by the power box, connect the CareView 750Cw/CareView 750C with
power box via the interface cable. Then, connect the power box with the DROC workstation directly
via a Cat5e/Cat6 network cable. See the figure on the following page for more details.
Note: When detector is powered by power box, it must be installed in the bucky.