Operation Manual

Page 28 of 57
RD-OI-20 A/3
Figure 19 Turn on the detector
3 Connect one end of the LAN cable to the wireless AP and power it on. Connect the other end to
the LAN card connector of the workstation assigned for the data transfer.
Figure 20 Connection wireless AP and workstation
4 When the detector and wireless AP are connected, the blue network LED light will blink, as shown
in the figure below.
Figure 21 Network LED
5 When you have finished using the detector, press and hold the power button of the detector for 3
seconds to turn off the detector. Remove the battery from the detector if the detector will not be
used in the near future. This is to prevent over-discharge of the battery, which may result in a
shortened battery life.
Power LED
Network LED