Operation Manual

Page 30 of 57
RD-OI-20 A/3
Figure 24
5 Connect the AC power cable with the power box and plug the power cable in the AC outlet.
Figure 25
6 Verify that the other connections are correct and safely secured. Then, switch on the power supply
to test electrical conductivity. Verify that the indicator lights of the power box and detector are
functioning normally.
Figure 26
7 Connect the synchronization cable between the power box and the X-ray generator if CareView
750C works in external sync mode
 One end of the sync cable is the 4pin RJ-11 connector; connect it with the “SYNC” port of
power box.
Power LED