User's Manual

14
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
condition.(1).this device may not cause harmful interference. (2)
.this device must accept any
interference received, including interference that may cause undesired operation
Warning:
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
used and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference in to radiate communications. However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
l Reorient or relocate the receiving antenna
l Increase the separation between the equipment and receiver.
l
Connect the equipment into an outlet on a circuit different form that to which the receiver
in connected.
l Consult the dealer or an experienced radio/TV technician for help.
Notice:
(1) An Unshielded-type power cord is required in order to meet FCC emission limits and also
to prevent interference to the nearby radio and television reception. It is essential that only the
supplied power cord by used.
(2) Use only shielded cables to connect I/O devices to this equipment.3
(3) Changes or modifications not expressly approved by the party responsible for compliance
could void the use’ s authority to operate the equipment.
Trademark Acknowledgments
All brand names and trademarks are the property of their owners.