User's Manual

22
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two condition.(1).this device may not cause harmful interference. (2).this
device must accept any interference received, including interference that may cause
undesired operation
Warning:
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, used and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference in to
radiate communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
l Reorient or relocate the receiving antenna
l Increase the separation between the equipment and receiver.
l Connect the equipment into an outlet on a circuit different form that to which the
receiver in connected.
l Consult the dealer or an experienced radio/TV technician for help.
Notice:
(1) An Unshielded-type power cord is required in order to meet FCC emission limits and
also to prevent interference to the nearby radio and television reception. It is essential
that only the supplied power cord by used.
(2) Use only shielded cables to connect I/O devices to this equipment.3
(3) Changes or modifications not expressly approved by the party responsible for
compliance could void the use’ s authority to operate the equipment.