User's Manual

gp()pg

pull straight out of the motherboard slot. If the card is stuck, rock from side

to side to dislodge it. Remember to keep the screw.

4. Locate the empty slot in the motherboard and then install the card in the

AGP bus slots

5. Replug the cable into the computer and replace the cover.

2.3 Installing notice (5700 Ultra only)

1. In order to make your system more stable, we recommend the minimum

requirement for the power supply is 300 Watts.

2. To ensure optimal performance, verify that the Molex hard drive power

connector is properly connected to the white port on the edge of the

graphics card. Failure to do so will result in running in a lower operating

frequency and therefore result in decreased performance.

3. If you experience any problems upon boot up, please verify that the

motherboard is of the AGP 2.0/3.0 specification. Please check with the

motherboard manual or consult with your motherboard manufacturer.

4. How to use the power connector port:

GPU

Power Connector

Yellow

(+12V)

Black (GND)

Red (+5V)

Power Cable (from your power supply)