MINISCALE Operation Manual
(1). Introduction This professional video scaler is designed to convert Composite and S-Video to high definition DVI resolutions. It handles video input from TV systems of NTSC, PAL TV standards with many great features to enhance video performance. (2). Features 1. Motion adaptive 3D Y/C separation comb filter ( for composite video input ) 2. 3D( frame Based ) motion adaptive YNR/CNR noise reduction ( for Y/C video input ) 3. Advanced 3D motion adaptive deinterlace 4.
(4). Operation Controls and Functions Front Panel POWER INPUT MENU CV SV CM-1391 Video to DVI Scaler Box 1 2 3 4 5 6 1. Power button and LED indicator: Press the button once to power on the unit, Press again to power off. when the unit is powered on, one of the input LEDs will illuminate depending on your last selection of input source before power off. The factory default setting for the input is CV (composite video). The green LED illuminates when composite video is selected.
(5). Output Format a. The format of digital DVI output is digital RGB for all resolutions. -RGB -RGB -RGB -RGB -RGB -RGB 1600 x 1200 UXGA 1920 x 1200 WUXGA -RGB HDTV (RGBHV) 1080p-RGB 1920x1080p follow input source 1080i-RGB 1920x1080i follow input source follow input source 1280X720 720p-RGB 576p-RGB 720X576 480p-RGB 720X480 b. The format for analog PC output is RGB and for analog HD output is YPbPr.
Output Setup When Output Set up is selected a submenu as below appears: Output Setup Timing XGA Exit Press the " MENU/ENTER" button to enter into output timing select mode. Press +,- to toggle through a variety of output resolutions as below. Once your desired resolution is selected. press the menu/enter to enter the resolution.
(8). Remote Control 1. Display: Press the button to display input source and output resolution on the screen. 2. Power: Power ON/OFF button. 3. VGA~1080p: Press to select your desired output resolution. 4. Picture: Press the button to enter picture adjust submenu. Use +,- button to move cursor (V) up/down to your desired parameter, press "Picture" again to confirm. 5. +/-: Press to move up/down the cursor (V) to your desired parameter,or press to increase/decrease the setting value. 4 6.