Specifications

4.4. Remote Control

1. POWER:

Press the button once to power on the Multiscale

Press again

to enter standby mode.

2. INPUT:

Press the button repeatedly to toggle through

various input sources.

3. HD Input:

Press the button to directly select component input.

4. PC Input:

Press the button to directly select PC input.

5. HDMI/DVI Input:

Press the button to directly select DVI (or HDMI) input.

6. Output Resolution:

Press any one of the button to directly select output

resolution. For other output resolutions that are not covered

by these buttons please enter OSD Menu to select them.

7. MENU:

Press the button to bring up OSD main menu page.

8. Exit:

Press the button to exit from a sub menu or main menu.

9. Up/Down/Left/Right:

Press the Up/Down button to move the highlight bar to your desired parameter during the

OSD operation. Press the Left/Right button to increase/decrease the setting value of a

selected parameter.

10. OK (Enter):

Press the button to confirm your selection.

11. Reset:

Press the button to reset the unit's firmware setting to the factory default value.

12. Auto Adjust:

Press the button to optimize the position of the picture (picture centering) on the screen.

Specifications

5.1. General Speciﬁcation

* Frequency bandwidth: 1.65Gbps (single link)

* Input Ports:

Composite x 1 / L/R x 1

S-Video x 1 / L/R x 1

Component (3 RCA) x 1 / L/R x 1

PC D-Sub (15-pin) x 1 / 3.5mm Phone Jack x 1

HDMI x 1 / 3.5mm Phone Jack x 1 (for DVI) Coaxial (S/PDIF) x 1

* Output Ports: HDMI x 1

Coaxial (S/PDIF) x 1

* 5V DC power supply

Dimensions: 215(W) x 154(D) x 47(H)mm*

Weight: 1K