User manual

b) Securing the motorised ceiling mount

Start by securing the ceiling mount (A) to your concrete, brick, or other ceiling using the screws and dowels provided

(see parts list). The mounting instructions are the same for sloping ceilings.

• Use the drill template provided to mark the positions of the drill holes. Drill the holes to the correct diameter and

depth (refer to the specications in the diagram above).

• Insert the two screws that you are going to x to the key-shaped holes on the ceiling mount, allowing them to

protrude about 5 mm from the ceiling.

• If you are securing the TV mount to a non-mineral surface or ceiling (e.g. wood), follow the steps above, but use the

screws without dowels and make the holes slightly smaller (4.5 mm wide and 55 mm deep).

• If you are securing the TV mount to a surface in a lightweight construction, refer to the specic instructions for the

mounting components that you are using.

• Slide the TV mount into the screws on the ceiling/surface and insert the remainder of the screws as shown above.

• Align the TV mount in a straight position and secure all of the screws with a Phillips screwdriver.