OWNER’S MANUAL CRS3 In-Ceiling Loudspeaker
INTRODUCTION Congratulations on purchasing SpeakerCraft’s CRS3 architectural loudspeaker. The CRS3 features a small footprint allowing them to blend seemlessly with most common in-ceiling lighting fixtures. SPEAKER PLACEMENT When following the below recommendations, please keep in mind that placement is always in the ceiling. SpeakerCraft recommends the use of a qualified custom installation specialist when installing your CRS3 speakers.
SPEAKER INSTALLATION The unique integral four foot mounting system incorporated into each speaker allows for quick installation following these easy steps: Flange Mounting Feet 1. If the grille is on the speaker, remove it. It may be necessary to push one or two of the mounting screws and its attached foot towards the baffle and against the inside surface of the grille to force the grille out of its retaining groove. 2.
SPECIFICATIONS CRS3 Speaker Type: Small Footprint In-Ceiling Woofer: 3" Full Range Aluminum Cone Woofer Impedance: 8 Ohms Sensitivity: 86dB 1W/1m Frequency Response: 80Hz - 16kHz Power Handling: 40 watts Cut Out Dimensions: 4 1 ⁄4 " (108mm) Dimensions (Diameter x Depth): 5 1 ⁄8 " x 3 1 ⁄4 " (130mm x 83mm) In our attempt to constantly improve our products, features and specifications are subject to change without notice. LIMITED LIFETIME WARRANTY SpeakerCraft Inc.