OWNER’S MANUAL AccuFit CRS7 In-Ceiling Loudspeaker AccuFit CRS7 Three | AccuFit CRS7 One
INTRODUCTION Congratulations on purchasing SpeakerCraft’s AccuFit CRS7 Series of architectural loudspeakers. The AccuFit CRS7 Series features a shallow 2 3⁄4" sealed steel enclosure. Speakercraft offers the AccuFit Series to address space limitations, building codes, sound transfer to adjoining walls and living environment concerns.
INSTALLATION CONSIDERATIONS Prior to the actual installation of the speakers, it will be necessary to run cables to the speaker location. See your Authorized SpeakerCraft dealer for more information on cable installation. After the cable has been installed, you are ready to mount the speakers. Preparation for and mounting of the speakers can happen at two different stages. If you are building a new ceiling, follow the section titled INSTALLATION PREPARATION - NEW CONSTRUCTION.
SPEAKER INSTALLATION The unique integral four foot mounting system incorporated into each speaker allows for quick installation following these easy steps: Figure 4 1. If the grille is on the speaker, remove it. It may be necessary to push one or two of the mounting screws and its attached foot towards the baffle and against the inside surface of the grille to force the grille out of its retaining groove. 2.
SPECIFICATIONS AccuFit CRS7 Three AccuFit CRS7 One Speaker Type: 2 Way Shallow-Depth, fully sealed Steel Enclosure 2 Way Shallow-Depth, fully sealed Steel Enclosure Tweeter: 3 ⁄4" Aluminum Dome Tweeter 3 Woofer: 7" Aluminum Cone Woofer 7" Polypropylene Cone Woofer Impedance: 8 ohms 8 ohms Sensitivity: 92dB 1W/1m 92dB 1W/1m Frequency Adjustments: Front-Mounted Treble Switch allows the Treble to be set at one of 3 positions: –3dB, Flat, +3dB None Frequency Response: 50Hz - 20kHz 50Hz -
940 Columbia Ave., Riverside CA 92507 | USA (800) 448 0976 Fax (951) 787 8747 International +1 951 787 0543 | www.speakercraft.
