OWNER’S MANUAL AccuFit Ultra Slim In-Ceiling Speaker AccuFit Ultra Slim Three | AccuFit Ultra Slim One
INTRODUCTION Congratulations on purchasing SpeakerCraft’s AccuFit Ultra Slim Series of architectural loudspeakers. The AccuFit Ultra Slim Series features a shallow 2" sealed steel enclosure. Speakercraft offers the AccuFit Series to address space limitations, building codes, sound transfer to adjoining walls and living environment concerns.
INSTALLATION CONSIDERATIONS Prior to the actual installation of the speakers, it will be necessary to run wiring to the speaker location. See your Authorized SpeakerCraft dealer for more information on wiring installation. After the wire has been installed, you are ready to mount the speakers. Preparation for and mounting of the speakers can happen at two different stages. If you are building a new ceiling, follow the section titled INSTALLATION PREPARATION - NEW CONSTRUCTION.
SPEAKER INSTALLATION The unique integral four foot mounting system incorporated into each speaker allows for quick installation following these easy steps: 1. If the grille is on the speaker, remove it. It may be necessary to push one or two of the mounting screws and its attached foot towards the baffle and against the inside surface of the grille to force the grille out of its retaining groove. 2.
SPECIFICATIONS AccuFit Ultra Slim Three AccuFit Ultra Slim One Speaker Type: 3-Way Shallow-Depth, Ported, Magnetically Sealed Steel Enclosure 3-Way Shallow-Depth, Ported, Magnetically Sealed Steel Enclosure Tweeter: 3 3 (2) Custom Aluminum Dome Midrange Drivers (2) Custom Aluminum Dome Midrange Drivers Woofer: (2) 3" Custom Aluminum Cone Woofers (2) 3" Custom Polypropylene Cone Woofers Impedance: 8 ohms 8 ohms Sensitivity: 90dB 1W/1m 89dB 1W/1m Frequency Response: 90Hz - 20kHz 90Hz - 20
940 Columbia Avenue, Riverside, CA 92507 | USA (800) 448 0976 Fax (951) 787 8747 International +1 951 787 0543 | www.speakercraft.
