Manualshelf

Installation Guide

ManualsBrandsSpeakman ManualsPlumbingNeo 1-Handle Universal Shower Valve Trim Kit in Brushed Nickel (Valve Not Included)
12345678910
4
Re-assemble the Bonnet Collar to the Delta Valve.
5
Secure the Wall Mounting Plate (1) to the Valve Mounting Plate (2) using the 8-32 X 1-1/8” Screws
(3) provided.
NOTE: The back surface of the Valve
Mounting Plate Assembly (1) should sit
flush against the wall when installed
correctly.
6
Confirm that the Valve is in the OFF position. Insert Spline Adapter (1) over Delta spindle (2),
aligning it to the flats on the Delta Spindle (2). Secure the Spline Adapter with the10-24 X ½”
Screw (3) provided.
7
Orient the Decorative Wall Plate (1) as shown below and insert the RED index button into the top
hole of the Wall Plate, and the BLUE index button into the lower hole. Slide Wall Plate Assembly
over Wall Mounting Plate (2).
RED
BLUE
8
Orient the Handle Assembly in a vertical position as shown below. Guide Handle Assembly onto
the Spline Adapter (3). While holding the Handle (1) stationary in the vertical position, thread the
Handle Escutcheon (2) onto the Wall Mounting Plate (4). Hand tighten until snug.