Installation Guide

3
Secure the Wall Mounting Plate (1) to the Valve Mounting Plate (2) using the 8-32 X 5/8” Screws
(3) provided.
NOTE: The back surface of the Valve Mounting Plate Assembly (1) should sit flush against the wall when
installed correctly.
4
Verify proper alignment of Moen Valve Spindle. Orient the Moen Valve Spindle so the side with the
smooth machined flat is facing upwards as shown below.
H CH
C
H C
H CH CH CH CH CH CH CH CH CH CH C
5
The Universal Valve Trim kit includes two Spindle Adapters that allow for both shallow and deep
mount installations. Observe the distance between the front lip of the Wall Mounting Plate and the
end of the Moen Spindle Hub as shown below to determine which Spindle Adapter to use.
• If the Moen Spindle Sleeve extends beyond the Wall Mounting Plate (1), Use Adapter “A”
• If the Moen Spindle Sleeve is recessed into the Wall Mounting Plate (1), Use Adapter “B.”
USE ADAPTER “A”
Wall Mounting Plate
Moen Spindle Sleeve
(Extended Position)
USE ADAPTER “B”
Wall Mounting Plate
Moen Spindle Sleeve
(Recessed Position)
ADAPTER “B”
ADAPTER “A”