Manualshelf

Installation Guide

ManualsBrandsSpeakman ManualsPlumbingNeo 1-Handle Universal Shower Valve Trim Kit in Brushed Nickel (Valve Not Included)
12345678910
6
Confirm that the Valve is in the correct orientation as described in Step 4. Insert Spline Adapter (1)
over Moen spindle (2), aligning it to the flats on the Moen Spindle (2). The extended “lug” on the
Spindle Adapter (1) should be positioned to the left of the Moen Valve Stop (4). One set of splines
on the adapter must be oriented perfectly vertical when installed, as shown below. Secure the
Spline Adapter with the 10-24 X 1/2” Screw (3) provided.
Align Vertically
7
RED
BLUE
Orient the Decorative Wall Plate (1) as shown below and insert the RED index button into the top
hole of the Wall Plate, and the BLUE index button into the lower hole. Slide Wall Plate Assembly
over Wall Mounting Plate (2).
8
Orient the Handle Assembly in a vertical position as shown below. Guide Handle Assembly onto
the Spline Adapter (3). While holding the Handle (1) stationary in the vertical position, thread the
Handle Escutcheon (2) onto the Wall Mounting Plate (4). Hand tighten until snug.