Installation Guide

INSTRUCTIONS FOR MODELS
92-S-2005-H-R1
NEED HELP?
TOOLS AND SUPPLIES
IMPORTANT
S-2005-H
ROUGH IN DIMENSIONS
Be sure to read instructions thoroughly before
beginning installation. Do not overtighten any
connections or damage may occur. This shower-
head has an operating range of 20-80 psi.
SAFETY TIPS
MAINTENANCE
Cover your drain to prevent loss of parts.
WARRANTY
Additional warranty information can be found at:
www.speakmancompany.com
For additional assistance or service please contact:
SPEAKMAN
®
Company
400 Anchor Mill Road
New Castle, DE 19720
800-537-2107
[e-mail]
www.speakmancompany.com
Thread Seal
Tape
Adjustable
Wrench
Periodic cleaning using a mild soap and warm
water will help keep your showerhead’s
appearance in its original condition.
For best results, dry immediately with a soft,
clean cloth. DO NOT USE harsh and/or abrasive
cleaners.
To help restore the finish, occasionally apply a
non-abrasive wax to your showerhead body
(follow manufacturers’ instructions).
On CHROME PLATED SHOWERHEADS, a
two (2) part white vinegar, one (1) part water
solution can be used to break down excessive
mineral deposits on the sprays. Let the showerhead
soak in the solution for about ½ hour then rinse
thoroughly. Brush off any remaining mineral
deposits if necessary.
DO NOT USE the vinegar/water treatment on
all special finishes (-BN, -ORB, -PN, -PB).
To reduce mineral build-up, turn the handle to
FLOOD position to let the water drain out after
every use.
Apply Thread Seal Tape to the outlet side of
shower arm in a clockwise direction.
Thread Showerhead onto shower arm by turning
it in a clockwise direction. Tighten with adjustable
wrench. Turn water supply on and check for
leaks.
5
1
2
"
139mm
4"
102mm
3
3
8
"
86mm
Specifications:
Inlet: 1/2” NPT FEMALE