Installation Guide

INSTRUCTIONS FOR MODELS
92-SA-2200-01
For additional assistance or service please contact:
SPEAKMAN
®
Company
400 Anchor Mill Road
New Castle, DE 19720
800-537-2107
[e-mail]
www.speakman.com
SA-2203 TOWEL RACK
SA-2204 7” TOWEL BAR
SA-2205 PAPER HOLDER
SA-2206 ROBE HOOK
SA-2207 24” TOWEL BAR
TOOLS AND SUPPLIES
Phillips
Screwdriver
Pencil
Drill Tile Drill Bit
ؼ”
Drill Bit
ؼ”
Level Hex Key
(included)
Hammer
Additional warranty information can be found at:
www.speakman.com
WARRANTY
MAINTENANCE
Cover your drain to prevent loss of parts.
SAFETY TIPS
IMPORTANT
• Be sure to read instructions thoroughly before
beginning installation.
• Do not over-tighten any connections or damage
may occur.
Your new Speakman Product is designed for years of
trouble-free performance. Keep it looking new by
cleaning it periodically with a soft cloth. The use of harsh
chemicals and abrasives on any of the Speakman custom
finish products may damage the finish and void the
product warranty. Please be sure to only use approved
cleaners. Please contact Speakman for any clarification
of acceptable cleaners.
1
The Mounting Plate (1) comes pre-installed
in the Accessory (2). Remove the Mounting
Plate(s) by loosening the pre-installed set
screw at bottom with the included Hex Key.
2
At the selected height, mark center point of
mounting locations onto wall referencing
the rough in diagram.
3
Align Mounting Plate over center point marked
in previous step. Mounting Plate should be
vertical with Notch in the cylinder (1) pointing to
the bottom as shown below. Mark Mounting
Screw locations onto the wall surface. Remove
items after marking mounting locations.
4
If mounting directly to wood stud, Plastic
Anchors are not required. If using anchors,
select proper drill bit for mounting location.
Drill ¼” holes in marked locations.
ؼ”
OR
5
Insert Plastic Anchors into drilled holes and
tap lightly with Hammer to fully seat Plastic
Anchor into the hole.