Installation Guide

IMPORTANT
MAINTENANCE
WARRANTY
INSTRUCTIONS FOR MODELS
92-SE-1000-1055-R4
NEED HELP?
TOOLS AND SUPPLIES
SAFETY TIPS
Be sure to wear eye protection.
For additional assistance or service please contact:
SPEAKMAN
®
Company
400 Anchor Mill Road
New Castle, DE 19720
800-537-2107
[e-mail]
www.speakmancompany.com
After referring to the Rough-In Diagram, select
a suitable plumb mounting location for the
Wall Bracket. Mark and drill holes according
to hardware selection specifications. Use
selected hardware to secure the Wall Bracket
to the mounting surface.
Insert 1-1/4” x 11-5/8” Pipe (opposite end
with Expansion Plug) into the Wall Bracket.
Tighten connection, being careful not to
damage finish.
Thread entire Bowl Assembly to the plugged
end of Pipe, ensuring the Bowl is level and
plumb when completely secured. Connect the
Drain Outlet to an adequate drain in
accordance with local plumbing codes.
3 year limited warranty.
Additional warranty information can be found at:
www.speakmancompany.com
OPTIMUS
™
SE-1000
SE-1050
SE-1055
ANSI Z358.1 states that weekly activation should be
conducted on all plumbed emergency equipment to ensure
that there is a suitable flushing fluid supply present and to
clear the supply line of any sediment build-up. Also per the
standard, the unit should be checked annually to ensure the
unit still complies with the installation section (7.4) of the
ANSI Z358.1 standard. ANSI Z358.1 specifies that the
height of the spray heads is to be between 33” - 45” from
the floor. The SE-1000/1050/1055 unit shall be mounted
ensuring the mounting surface (wall,etc.) and mounting
hardware are sufficient to carry the load. Be sure to read
instructions thoroughly before beginning installation. Use
thread locker on all threaded connections. Make sure
Eye/Face wash is level and plumb. Do not overtighten any
connections or damage may occur. SPEAKMAN furnishes
a testing record tag (91-0635) with each unit. On this tag,
the date of inspection and the inspector’s initials should be
noted.
Please reference the parts listing for the correct repair part
numbers. Only use genuine SPEAKMAN parts when
repairing or replacing components. To order parts, call
1-800-537-2107. Be sure to turn off water supplies before
beginning any maintenance. See Page 2 for cleaning
instructions.
Expansion Plug
Drain Outlet
Install Paddle Handle to Ball Valve with
Nut . Connect an uninterruptable potable
water supply with a minimum flowing presure of
30psi and a maximum static pressure of 60psi
to the 1/2” NPT female water supply inlet.
1
2
3
1
3
2
1/2” NPT
Female Inlet
To test, and for subsequent operation, push
the Paddle Handle forward 90˚. The unit will
operate until the Paddle Handle is manually
pulled back to the OFF position.
Level
Drill
Pencil
Adjustable
Wrench
Pipe
Wrench
Measuring
Tape