Installation

Page 6 of 15
SPEAKMAN
®
400 Anchor Mill Rd. New Castle, DE 19720 Phone: [phone] Fax: [phone]
1/15/16 www.speakman.com 92-S-9100-9200-05
After screw has been removed from the unit, pull up
faucet body top. There are 2 O-Rings on the shank
and one around the lenses of Sensor Module that
should be replaced if damaged.
Remove the 2 screws on the clamp. After removing,
pull up the Sensor Module from the central shank (do
not damage the O-Rings and the wire connectors).
Reassemble new Module with care not to cut wires
through the big holes into the Base, and then insert
the clamp with the Sensor over the shank. Tighten the
2 screws on clamp, making sure that the sensor sits on
the flat of shank and touches the bottom of base.
Grease the 2 O-Rings or change them if they are
damaged. Take care when inserting Faucet Spout over
the Sensor O-Ring and tighten the screw that was
removed in the back.
REPLACEMENT OF BATTERIES
To replace the batteries (if the unit purchased is a
battery powered unit) first start by unscrewing the
screw that is on the power module.