Installation

INSTRUCTIONS FOR MODELS
92-SA-1009-02
For additional assistance or service please contact:
SPEAKMAN
®
Company
400 Anchor Mill Road
New Castle, DE 19720
800-537-2107
[e-mail]
www.speakman.com
SA-1009-24
SA-1009-36
SA-1009-48
SA-1309-24
SA-1309-36
SA-1309-48
HELPFUL TOOLS & SUPPLIES:
TOOLS AND SUPPLIES
LevelPhillips
Screwdriver
Pencil
Drill Tile Drill Bit
3/16” (#12)
Silicone
Measuring
Tape
Stud Finder
Safety
Glasses
Caulk Gun
Warranty information can be found at:
www.speakman.com
WARRANTY
MAINTENANCE
Your new Speakman Product is designed for years of
trouble-free performance. Keep it looking new by
cleaning it periodically with a soft cloth. The use of harsh
chemicals and abrasives on any of the Speakman custom
finish products may damage the finish and void the
product warranty. Please be sure to only use approved
cleaners. Please contact Speakman for any clarification
of acceptable cleaners.
Cover your drain to prevent loss of parts. Be sure to
wear eye protection while cutting pipe.
SAFETY TIPS
IMPORTANT
• Be sure to read instructions thoroughly before
beginning installation. Do not overtighten any
connections or damage may occur. This Grab Bar
meets ADA requirements when installed properly.
• This product is considered ADA compliant when
located and mounted into a structural support per
ADA guidelines. Refer to ADA guidelines before
installing this product.
• Before installing finished wall material, install
bracing between the wall studs where the wall
plates will be mounted.
• The appearance of your product may differ from
the illustration. The installation instructions still apply.
• Observe all local plumbing codes and building
codes.
WARNING: Risk of personal injury. The wall
plates on the grab bar must be mounted to the
brace between the wall studs. Doing so will
ensure that the weight of the user is adequately
supported.
CAUTION: Risk of property damage. For
installation to ceramic tile: Apply light, even
pressure to avoid cracking the tile. Use a
3/16” or #12 drill bit to drill through the tile.
Do not drill into the bracing.
WARNING: Risk of property damage. For
installation to ceramic tile: Apply silicone
sealant into the drilled holes before securing
the wall plates to the finished surface. This will
reduce the risk of water damage behind the
finished surface.
1
Place Grab Bar in desired position on wall,
being sure that there is sufficient blocking within
the wall. Level if desired. Mark three ( 3 )
holes from each Wall Plate onto wall with pencil.
NOTE: If installing thru drywall, proceed to
Step 4.
2
IF MOUNTING THRU TILE WALL:
Drill thru tile only using a 3/16” (#12) drill bit
that is designed for tile.
3
IF MOUNTING THRU TILE WALL:
Apply Silicone Sealant into the six (6)
drilled holes.