Installation

INSTRUCTIONS FOR MODELS
92-SA-2000-04
For additional assistance or service please contact:
SPEAKMAN
®
Company
400 Anchor Mill Road
New Castle, DE 19720
800-537-2107
[e-mail]
www.speakman.com
SA-2003 TOWEL RACK
SA-2004 TOWEL RING
SA-2005 PAPER HOLDER
SA-2006 ROBE HOOK
SA-2007 TOWEL BAR
SA-2010 DOUBLE PAPER HOLDER
TOOLS AND SUPPLIES
Phillips
Screwdriver
Pencil
Drill Drill Bit
Ø3/16”
Level
Hex Key
(included)
Phillips
Drive Bit
Additional warranty information can be found at:
www.speakman.com
WARRANTY
MAINTENANCE
Cover your drain to prevent loss of parts. Be sure to
wear eye protection while cutting pipe.
SAFETY TIPS
IMPORTANT
• Be sure to read instructions thoroughly before
beginning installation.
• Do not over-tighten any connections or damage
may occur.
Your new Speakman Product is designed for years of
trouble-free performance. Keep it looking new by
cleaning it periodically with a soft cloth. The use of harsh
chemicals and abrasives on any of the Speakman custom
finish products may damage the finish and void the
product warranty. Please be sure to only use approved
cleaners. Please contact Speakman for any clarification
of acceptable cleaners.
1
If the Mounting Plate(s) (1) come pre-installed in
the Accessory (2), remove the Mounting Plate(s)
by loosening the pre-installed set screw at bottom
with the included Hex Key.
2
At the selected height, mark center point of
mounting locations onto wall referencing
the rough in diagram.
3
Align Mounting Plate over center point marked
in previous step. Mounting Plate should be
vertical as shown below. Mark Mounting Screw
locations onto the wall surface. Remove items
after marking mounting locations.
4
If mounting directly to wood stud, Plastic Anchors
are not required. If mounting to tile, acquire
proper mounting hardware capable of supporting
the accessory in use. If mounting to drywall, drill
guide holes at marked locations using a Drill
equipped with a Ø 3/16" bit.
Ø
3
/16”
5
Insert Plastic Anchors into drilled holes and screw
in the anchor using a Phillips Head screwdriver,
or a Drill equipped with a Phillips Driver Bit until
the head is flush with the wall surface.
OR
6
Secure Mounting Plate with the Mounting Screws
provided. Verify that the Mounting Plate is
aligned vertically.