Spec Sheet

THIS SPACE FOR ARCHITECT/ENGINEER APPROVAL.
400 ANCHOR MILL ROAD | NEW CASTLE, DE 19720
P: 800-537-2107 | F: 800-977-2747
WWW.SPEAKMANCOMPANY.COM
REVISION DATE: DECEMBER 2014
SPECIFICATION
149
Management Systems
Registered to ISO 9001
SEE REVERSE FOR ROUGH-IN DIMENSIONS
SPEAKMAN
®
Rive™ Single Lever Faucet
SB-2111
FEATURES:
• Lead-free brass construction
• Ceramic cartridge
• Transitional Styling
• Includes Pop-up Drain
• 1.5 gpm (5.7 L/min) ow rate
COMPLIANCE:
ASME A112.18.1/CSA B125.1 certied
• NSF 61 certied
• WaterSense Certied
• NSF 372 Compliant
• ADA compliant
FINISHES:
ADD SUFFIX TO MODEL #
• Polished Chrome (standard)
• Brushed Nickel -BN
WARRANTY:
• Limited Lifetime Warranty (consumer use)
• 5 Year Limited (commerical use)
Instructions for Models:
For additional assistance or service call:
SPEAKMAN Company
400 Anchor Mill Road
New Castle, DE 19720
PHONE: 800-537-2107
EMAIL: customerservice@speakmancompany.com
WEB: www.speakmancompany.com
Important Notes:
Be sure to read instructions thoroughly before
beginning installation. Do not overtighten any
connections or damage may occur. This faucet has
an operating range of 20-80 psi.
Safety Tips:
Cover your drain to prevent loss of parts.
Be sure to wear eye protection while cutting pipe.
Maintenance:
Your new Lavatory Faucet is designed for years
of trouble-free performance. Keep it looking new
by cleaning it periodically with a soft cloth.
Avoid abrasive cleaners, steel wool, and harsh
chemicals as these will dull the finish and void
your warranty.
Remove flange (1) and rubber washer (2) from
POP-UP drain assembly.
SB- -BN2111
SB-2111
92-SB-2111-R1
Need Help?
Shut off water supplies.Remove old faucet.Place
gasket (1) on bottom of new faucet.Place faucet
through mounting holes in sink.Secure faucet to
sink using mounting nuts (2) and washers provided.
1
2
3
1
2
1
2
3
1
2
Make connections to water lines.Use 1/2” IPS
faucet connections (1), or use 3/8O.D. ball
nose risers (2) with coupling nuts (3).Use wrenches
to tighten connections.Take care to not overtighten.
Place the rubber washer (2) to underside of the
flange (1). Insert the threaded end of the drain
body up through the drain hole and attach flange to
the body with the pivot hole (3) pointing to the rear
of the sink.
Unscrew the nut (1) from the pop-up body.
NOTE:Retain the seal (2) on the pivot rod (3).
Place the nut onto the pivot rod insert the rod and
seal (2) into the pivot hole (4) .Install stopper (5) as
shown (6) .Slide nut (1) on and hand tighten.
(Please do not overtighten).
4
5
1
2
3
5
4
2
1
3
What You Need To Know:
Tools:
Required:
*
Wrench
Adjustable
Helpful:
*
Pliers
Groove Joint
*Thread Seal Tape
*Supply Lines *Basin Wrench *Pipe Wrench
*Hacksaw *Tubing Cutter *Utility Knife
*Eye Protection
*
Screwdriver
Philips
6
NSF 372

Summary of content (2 pages)