Installation

21
Zip up open portion of Jacket (1). Verify all wiring is within Jacket and not kinked. Verify
AC Plug Adapter is fully extended through the Jacket (2). Velcro close the flap.
ACTIVATION INSTRUCTIONS
STEP 1: Follow instructions shown on the
front of the jacket Access Panel.
CERTIFIED TO ANSI/ISEA Z358.1
STEP 2: To activate the flow of water,
firmly remove the front panel as shown.
Fully removing both covers from the Spray
Heads.
22
Plug the unit into the power supply.
AC Electrical Supply
The Ground Fault Circuit Interrupter (GFCI) plug
is to be used in accordance with appropriate
electric codes and regulations. Use this device
with a grounded circuit receptacle rated at
120VAC, 15A.
The GFCI device protects against current
leakage caused by ground faults only. It does
not protect against over current or short circuits.
TEST INSTRUCTIONS
1. Plug device into receptacle.
a. AUTO-RESET devices: Pilot light goes ON.
2. Press TEST button – Pilot light must go OFF.
3. Press RESET button and release – Pilot light
must go ON for use.
CAUTION: Do not use this device if above test
fails. Test unit before each use.
FOR DRAINING AND MAINTENANCE
To periodically drain the unit, Lift Flap (1) and velcro in place. Remove the Drain Plug (2). Once
all water is removed, reinstall the Drain Plug and hand tighten into position. Take care to not over
tighten or damage may occur.
See Maintenance Section for further detail.
See Maintenance Section for further detail.
When the thermostat is disconnected or open
circuit is detected, “LL” (1) is displayed and alarm
LED (2) will flash.
TROUBLESHOOT
Confirm wiring connectors from heater pad to
controller are mated properly.
Confirm wiring connectors from thermostat to
controller are mated properly.
SPEAKMAN
®
SE-4930 CONTROLLER INTERFACE
LL
LL
SET
+
°F
FAILURE INDICATOR DISPLAY
FLASHING ALARM INDICATOR
Default Settings:
SET Point = 75° F
Lower Limit = 60° F
Upper Limit = 90° F
Turn unit on: Current / Actual water temperature
will be displayed (1).
Temperature units to be in Fahrenheit (°F) (3).
Heating function indicator displayed means heater
is on (4).
69.5
SET
+
°F
CURRENT WATER TEMPERATURE
TEMPERATURE SET BUTTON
TEMPERATURE UNITS
HEATER ON INDICATOR
Heater Temperature Controller Model ED330
NOTE: During initial startup, the water temperature may
not be in the tepid range (60-90 F). Once plugged in, the
heating unit will warm the temperature up to the tepid
range. Depending on the water temperature within the
tank and the ambient conditions, it may take up to 24
hours for the water temperature to reach the tepid range.
AC Electrical Supply
The Ground Fault Circuit Interrupter (GFCI) plug is to be used in
accordance with appropriate electric codes and regulations. Use this
device with a grounded circuit receptacle rated at 120VAC, 15A.
The GFCI device protects against current leakage caused by ground
faults only. It does not protect against over current or short circuits.
TEST INSTRUCTIONS
1. Plug device into receptacle.
a. AUTO-RESET devices: Pilot light goes on.
2. Press TEST button – Pilot light must go off.
3. Press RESET button and release – Pilot light must go ON for use.
CAUTION: Do not use this device if above test fails. Test unit before
each use.
* CONTROLLER SETTINGS ARE PRE-SET FROM FACTORY *
NORMAL DISPLAY MODE
FAILURE MODE