Installation

11/09
92-1461
Rev-10
MAINTENANCE
The valve and the eyewash are the only
portions of the unit that may require
maintenance. Should you need parts to repair
this unit, please reference the parts listing
below for correct part numbers. Before any
maintenance is done be sure to shut the water
supply off.
Replace the water and clean the
tank at least once a month. To clean the tank,
drain the water through the hand held drench
hose of the eyewash. Refill as instructed in the
operation section.
WARNING: Use only genuine Speakman
parts when repairing or replacing
components. To order
parts call 1-800-537-2107.
SE-590 REPLACEMENT/REPAIR
PARTS
ITEM PART/GROUP #
DESCRIPTION
1 G05-0735 Low Flow Bullhorn Assy.
2 RPG20-1978 Non-Aerated Drench Hose Assy.
3 04-0832 Paddle Handle
4 05-1670-MO Tank- 10 Gal S/S
5 05-1671-MO Pressure Gauge
6 20-0756-RCP 3/8” Apollo Ball Valve
7 24-0268-RCP Air Inlet Tee
FLOW DATA
EYEWASH:
HAND-HELD SPRAY
FLOW RATE GPM (LPM) 1.5 (5.6) For 5 minutes.
FLOW RATE GPM (LPM) .4 (1.5) For 15 minutes.
Note: All units meet existing
ANSI Z358.1 Standards and
OSHA Rules. Product
improvements may cause
specification and
dimensional changes
without notice.