Installation

ManualsBrandsSpeakman ManualsPlumbingSentinel Pro Collection 2.5 GPM Wall Mounted Shower System, Includes Valve Trim, Hand Shower, Slide Bar, in Polished Chrome

SPEAKMAN

400 Anchor Mill Rd. New Castle, DE 19720 Phone: 800-537-2107 Fax: 800-977-2747

12/04/17 www.speakman.com 92-SM-5480-ADA-01

SPEAKMAN

SM-5480-ADA

Installation, Operation & Maintenance Instructions

SENTINELPRO™ COMBINATION SERIES

DESCRIPTION

Speakman SentinelPro™ Combination, SM-5480-ADA, unites Anti-Scald Thermostatic / Pressure Balance

Diverter Shower/Bath Valve with integral Check Stops (CPV-TP-DV), Trim with integral Volume Control /

Diverter Handle (CPT-5401), Shower Arm with Wall Flange (S-2500), Hand Shower with flow control

(VS-100-PC), Shower Arm Bracket, In-line Vacuum Breaker, 60in Shower Hose (VS-152), and 24in ADA

Combination Grab/Slide Bar (VS-153-ADA).

SPECIFICATIONS

CPV-TP-DV ANTI-SCALD THERMOSTATIC / PRESSURE BALANCE DIVERTER SHOWER VALVE:

CONNECTIONS: ½” Female Copper Sweat and ½” NPT Male at both the Inlets (Cold, Hot) & Outlets

(Shower, Tub)

FLOW RATE: 1.5 gpm (5.7 L/min) or higher

COMPLIANCE: ASSE 1016 / ASME A112.1016 / CSA B125.16 & ASME A112.18.1 / CSA B125.1 Standards

CPT-5401 T/P DIVERTER VALVE TRIM:

FINISH: Polished Chrome

COMPLIANCE: ASME A112.18.1 / CSA B125.1 Standard

S-2500 SHOWER ARM WITH WALL FLANGE:

CONNECTIONS: ½” NPT Male Inlet & Outlet

FINISH: Polished Chrome

VS-1001-ADA-PC HANDICAP SHOWER COMBINATION:

VS-100-PC HAND SHOWER WITH FLOW CONTROL:

CONNECTIONS: ½” NPSM Male Inlet

FLOW RATE: 2.5 gpm (9.5 L/min)

FINISH: Polished Chrome

COMPLIANCE: ASME A112.18.1 / CSA B125.1 Standard

SHOWER ARM BRACKET:

CONNECTIONS: ½” NPSM Male Inlet; ½” NPSM Female Outlet

FINISH: Polished Chrome

IN-LINE VACUUM BREAKER:

CONNECTIONS: ½” NPSM Female Inlet; ½” NPSM Male Outlet

FINISH: Polished Chrome

VS-152 60in SHOWER HOSE:

CONNECTIONS: ½” NPSM Female Inlet & Outlet

FINISH: Polished Chrome

VS-153-ADA 24in ADA COMBINATION GRAB/SLIDE BAR:

FINISH: Polished Chrome

COMPLIANCE: Meets 250 lbs pull test for Grab Bars per ANSI Standard;

Meets requirements of ADA Lever Handle for adjusting Slide Bar

Summary of content (18 pages)

PAGE 1
SPEAKMAN ® SM-5480-ADA Installation, Operation & Maintenance Instructions SENTINELPRO™ COMBINATION SERIES DESCRIPTION Speakman SentinelPro™ Combination, SM-5480-ADA, unites Anti-Scald Thermostatic / Pressure Balance Diverter Shower/Bath Valve with integral Check Stops (CPV-TP-DV), Trim with integral Volume Control / Diverter Handle (CPT-5401), Shower Arm with Wall Flange (S-2500), Hand Shower with flow control (VS-100-PC), Shower Arm Bracket, In-line Vacuum Breaker, 60in Shower Hose (VS-152), and 24in ADA
PAGE 2
INSTRUCTIONS See individual products for installation of the components and warranty information. ROUGH-IN SPEAKMAN ® 400 Anchor Mill Rd. New Castle, DE 19720 Phone: 800-537-2107 Fax: 800-977-2747 12/04/17 www.speakman.
PAGE 3
INSTRUCTIONS FOR MODELS TOOLS AND SUPPLIES CPV-TP CPV-TP-DV Pencil Keyhole Saw Adjustable Wrench 1 IMPORTANT • Be sure to read instructions thoroughly before beginning installation. Referencing the supplied rough-in dimensions (located at the end of this manual), determine the preferred location of valve. Align the supplied rough-in template with this location and trace outline of template onto wall.
PAGE 4
6 If your installation is for a shower only, apply thread seal tape to the lower outlet port and install the included cap. Wrench tighten. 7 Ensure Valve is positioned plumb and level. Remove Rough-In Template from Valve. Make threaded connections or plumb and solder all joints and fittings. Take care to protect surrounding area when soldering. Secure piping to surrounding structure. 8 OR Make piping connections for all accessories. Take care to protect surrounding area when soldering.
PAGE 5
CPV-TP / CPV-TP-DV SERVICE INSTRUCTIONS Service instructions Caution- Any repair or servicing of the valve may affect the maximum hot temperature setting of the valve. After working on the valve, make sure the maximum hot water temperature is set to the recommended setting of 110° F maximum. T/P Cartridge Removal 1) Shut off the hot & cold water supply integral stops at the valve. Remove valve trim from valve.
PAGE 6
SPEAKMAN CPV-TP ROUGH-IN DIAGRAM ® A NOTES: COMPLIANCE: ASME A112.18.1/CSA B125.1 1" 25mm HOLE FOR SHOWER ARM Shower Valve ASSE1016 6'-6" [2 METERS] TO FLOOR CONNECTIONS: 1/2" NPT MALE 1/2" SWEAT CONNECTION Hot/Cold Inlets: ½” Female Copper Sweat ½” NPT Male 5-1/2" (140MM) DIA.
PAGE 7
INSTRUCTIONS FOR MODELS CPT-5001 / CPT-5401 TOOLS AND SUPPLIES Phillips Screwdriver Silicone 1 Remove the Handle Button Screw by inserting one of the included Mounting Screws thru the hole in the Handle. Caulk Gun IMPORTANT • Do not over-tighten any connections or damage may occur. • Be sure to read instructions thoroughly before beginning installation. 2 Insert the T/P Rubber Sleeve with Tabs over Valve Bonnet. • This valve has an operating range of 20-80 psi.
PAGE 8
Ensure the Rubber Gasket is correctly installed to the Retaining Ring. Align the Retaining Ring with the slots on the Wall Plate. Press and Rotate the ring clock-wise until it Locks / Seals in place. Make sure the seal is secure with the Wall Plate. 10 Insert Handle Button into the Handle. * VIEW FROM BACK UNDERSIDE OF HANDLE If further adjustments need to be made after the Handle Button is inserted, there is an access hole at the back side of the handle. Use a paper clip to push the Button back out.
PAGE 9
SPEAKMAN CPT-5001 ROUGH-IN DIAGRAM ® A 1" 25mm HOLE FOR SHOWER ARM 7.50in 191mm 6'-6" [2 METERS] TO FLOOR 1/2" NPT MALE 1/2" SWEAT CONNECTION 1/2" NPT MALE 1/2" SWEAT CONNECTION 5-1/2" (140MM) DIA. HOLE FOR VALVE ACCESS 4.31in 110mm 1/2" NPT MALE 1/2" SWEAT CONNECTION 3.50in 89mm 3.75in 95mm 1'-9" [533mm] VALVE MOUNTING IS SHOWN FOR REFERENCE ONLY. VALVE IS NOT INCLUDED WITH CPT-5000 4’-6" [1.
PAGE 10
INSTRUCTIONS FOR MODELS TOOLS AND SUPPLIES S-2500 1 Place the Escutcheon Plate (1) on a flat surface. Push the long end of the Shower Arm (2) down into the plate. This will help the teeth of the plate slide over the arm easier. 2 Once the Escutcheon Plate (1) is on the shower arm, slide the plate over the Shower Arm (2). Thread Seal Tape 4 Position Escutcheon Plate (1) flat against wall. IMPORTANT Be sure to read instructions thoroughly before beginning installation.
PAGE 11
SPEAKMAN ® VS-2954, VS-1001-ADA-PC Installation, Maintenance & Operation Instructions ADA / HANDICAP SHOWER AND BAR DESCRIPTION Speakman ADA handicap shower system includes hand held shower (VS-100-PC), 5’ stainless steel hose with built in vacuum breaker, shower arm bracket, and 24” grab/ slide bar assembly (VS-153-ADA). Connects to standard shower arm. Shower arm flange (10-0219-PC-P) and 8” shower arm (42-0029-PC) for VS-2954 model only. Chrome handheld shower puts out 2.5 GPM/9.
PAGE 12
SPEAKMAN ® 400 Anchor Mill Rd. New Castle, DE 19720 Phone: 800-537-2107 Fax: 800-977-2747 9/08/17 www.speakman.
PAGE 13
INSTRUCTIONS FOR MODELS TOOLS AND SUPPLIES VS-100-PC VS-100-PC-E2 VS-100-PC-E175 1 Connect the correct side of your hose (not included) to the water supply. Hand tighten. 2 Connect remaining end of Hose to inlet of Hand Shower. Hand tighten. If there are leaks at the hose connections, look into using thicker washers to ensure a tight seal. Thread Seal Tape (included) IMPORTANT Be sure to read instructions thoroughly before beginning installation.
PAGE 14
ROUGH IN DIMENSIONS 50 RUBBER TIPPED SPRAYS 31" 8 79.38 81" 2 215.90 PAUSE BUTTON 1/2-14 NPSM MALE THREADED INLET FLOW CONTROL INSERTED INTO HANDLE .714in 18.14mm ACROSS FLATS 1 3 " 16 30.18 VS-100-PC Max. Flow Rate: 2.5 gpm (9.5L/min) Min. Flow Rate: 2.0 gpm (7.6 L/min) @ 45psi FOR USE WITH AUTOMATIC COMPENSATING VALVES RATED AT 7.6 L/MIN (2.0 GPM) OR LESS. VS-100-PC-E2 Max. Flow Rate: 2.0 gpm (7.6 L/min) Min. Flow Rate: 1.5 gpm (5.
PAGE 15
INSTRUCTIONS FOR MODELS VS-152 VS-152-6FT IMPORTANT 1 Be sure to read instructions thoroughly before beginning installation. Do not overtighten any connections or damage may occur. Thread end of hose to the outlet port of Bracket. Hand tighten. WATER WILL NOT FLOW THROUGH THE HOSE IF THE WRONG SIDE IS CONNECTED. ROUGH IN DIMENSIONS 1.1” [27mm] (1) O-RING 1.6” [40mm] SAFETY TIPS Cover your drain to prevent loss of parts.
PAGE 16
INSTRUCTIONS FOR MODELS VS-153-ADA -30 -36 VS-153-30-RT TOOLS AND SUPPLIES Pencil Phillips Screwdriver 1 IMPORTANT Drill Bit No.10/5.5mm • Meets the ANSI standard 250 lbs. pull-test for grab bars and ADA lever handle for adjusting slide bar. Remove Decorative Cover Plate from Upper Mounting Bracket. Slide Lower Decorative Cover Plate up and over Lower Mounting Bracket as shown below. • The VS-153-ADA Slide Bar meets ADA pull force requirements only. It is not intended to replace an ADA Grab Bar.
PAGE 17
7 8 Position the Slide Bar flush against the mounting surface and push the Slide Bar through the hole in the Upper Mounting Bracket. 9 Secure the Lower Mounting Bracket (1) in place to the wall using the Mounting Screws provided with a Phillips Screwdriver. Reinstall the Lower Decorative Cover Plate (2) to the Lower Mounting Bracket. Orient the Hand Held Shower Bracket to your desired position.
PAGE 18
VS-153-ADA-36 ROUGH-IN DIAGRAM SPEAKMAN ® SPEAKMAN VS-153-ADA REPAIR PARTS ® NOTES: 1.34in 33.91mm COMPLIANCE: ADA COMPLIANT 2in 50.80mm TYP. • Meets the ANSI standard 250 lbs. pull-test for grab bars and ADA lever handle for adjusting slide bar. 2.78in 70.73mm • The VS-153-ADA Slide Bar meets ADA pull force requirements only. It is not intended to replace an ADA Grab Bar. 5in 128.80mm 3.5in 87.63mm REF MOUNT COVER TYP 3.5in 89.66mm REF MOUNT HEIGHT TYP 5.1in 128.80mm REF HOLDER ARM LENGTH 36.