Installation Guide

What You Need To Know:
Tools:
Required:
*Adjustable
Wrench
Helpful:
Instructions for Models:
For additional assistance or service call:
SPEAKMAN Company
400 Anchor Mill Road
New Castle, DE 19720
PHONE: [phone]
EMAIL: [e-mail]
WEB: www.speakman.com
*Groove Joint
Pliers
*Teflon Tape
*Supply Lines *Basin Wrench *Pipe Wrench
*Hacksaw *Tubing Cutter *Utility Knife
Important Notes:
Be sure to read instructions thoroughly before
beginning installation. Do not overtighten any
connections or damage may occur. This faucet has
an operating range of 20-80 psi.
Safety Tips:
Cover your drain to prevent loss of parts.
Be sure to wear eye protection while cutting pipe.
Maintenance:
Your new Lavatory Faucet is designed for years
of trouble-free performance. Keep it looking new
by cleaning it periodically with a soft cloth.
Avoid abrasive cleaners, steel wool, and harsh
chemicals as these will dull the finish and void
your warranty.
*Eye Protection
*Philips
Screwdriver
Make connections to water lines.Use 1/2” IPS
faucet connections (1) or use the supplied coupling
nuts (3) with 3/8” O.D. ball nose risers (2).Use wrenches
to tighten connections.Do not overtighten.
SB- -E1821
SB-1821
92-SB-1821-R2
Need Help?
Shut off water supplies.Remove old faucet. Clean
sink surface in preparation for new faucet. Place
spout thru mounting hole in sink. Secure spout with
rubber washer ,metal washer and nut.
Slide Hot and Cold end valves thru sink mounting
holes. NOTE:Hot side end valve is labeled. Secure
end valves with washers and nuts. Hand tighten nuts
onto shank. Lock nuts into pisition by tightening screws.
Insert flexible hoses into the faucet base as shown,
tighten the handle with the clamp spring, and then
press the button of the spout in order to set flexible
hoses and the faucet.
1
2 5
4
3
3
1
2
Remove flange (1) and rubber washer (2) from
POP-UP drain assembly.
1
2